Manual Stanley DN55-8-5 (page 8 of 12) (English)

720675

Zoom out

Zoom in

1/12

● Donotsetupthecompressorindamporwetrooms.

● The compressor may only be used in suitable rooms

(with good ventilation and an ambient temperature from

+5°C to +40°C). There must be no dust, acids, vapours,

explosive gases or inflammable gases in the room.

● Thecompressorisdesignedtobeusedindryrooms.It

is prohibited to use the compressor in areas where work

is conducted with sprayed water.

6. OPERATION INSTRUCTIONS

6.1 Start-UpProcedures

1. VerifythattheOn/OffswitchisintheOffposition.

2. Verifythatthetankairpressureisat0PSI.

3. Attach the air hose to the discharge line.

4. Plug the unit into a properly grounded outlet.

5. Push the On/Off switch to On. The On/Off switch

will light-up to indicate the compressor is on. The

compressor will automatically cycle on and off to keep

the tank pressure maintained .

6. Adjust the pressure regulator to the proper pressure

setting required for the air tool.

6.2 Shut-OffProcedures

1. Push in the On/Off switch to the Off position.

7. CLEANING AND MAINTENANCE

Warning!

Pull the power plug before doing any cleaning and

maintenance work on the appliance.

Warning!

Wait until the compressor has completely cooled

down. Risk of burns!

Warning!

Always depressurize the tank before carrying out any

cleaning and maintenance work.

7.1 Cleaning

● Keep the safety devices free of dirt and dust as far

as possible. Wipe the equipment with a clean cloth or

blow it with compressed air at low pressure.

● We recommend that you clean the appliance

immediately after you use it.

● Clean the appliance regularly with a damp cloth

and some soft soap. Do not use cleaning agents or

solvents; these may be aggressive to the plastic parts

in the appliance. Ensure that no water can get into the

interior of the appliance.

● Youmustdisconnectthehoseandanysprayingtools

from the compressor before cleaning. Do not clean the

compressor with water, solvents or the like.

7.2 Drainingtank

The condensation water must be drained off each day

by opening the drain valve (ref. E) (on the bottom of the

pressure vessel).

1. VerifythatthecompressoristurnedOff.

2. Holding the handle, tilt the compressor toward the

drain valve so that they are positioned at the bottom of

the tank.

3. Turn the drain valve to open the valve.

4. Keep the compressor tilted until all moisture has been

removed.

Warning!

The condensation water from the pressure vessel

will contain residual oil. Dispose of the condensation

water in an environmentally compatible manner at the

appropriate collection point.

7.3 Safetyvalve(ref.G)

The safety valve has been set for the highest permitted

pressure of the pressure vessel. It is prohibited to adjust

the safety valve or remove its seal. Actuate the safety

valve from time to time to ensure that it works when

required. Pull the ring with sufficient force until you can

hear the compressed air being released. Then release the

ring again.

7.4 Storage

Warning!

Pullthemainsplugoutofthesocketandventilatethe

appliance and all connected pneumatic tools.

Switch off the compressor and make sure that it is

secured in such a way that it cannot be started up

again by any unauthorized person.

Warning!

Storethecompressoronlyinadrylocationwhichis

not accessible to unauthorized persons.

Always store upright, never tilted!

8. DISPOSAL AND RECYCLING

The unit and its accessories are made of various types of

material, such as metal and plastic.

Defective components must be disposed of as special

waste. Ask your dealer or your local council.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Stanley DN55-8-5 in the language / languages: English as an attachment in your email.

The manual is 1,35 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Stanley DN55-8-5 Manual

Product: