680825
66
Zoom out
Zoom in
Previous page
1/96
Next page
66
S10564-00001_Rev-A_EN
11. Connections and special functions of the wall
control unit
11.10 Installing and removing battery
pack
The battery pack can bridge approximately 5 cycles
within 12 hours in the event of a power failure. If the
factory settings are active, the door does not open if the
battery is low. If DIP switch 4 on the wall control unit is
set to ON, to door opens even if the battery is low.
Only a qualified electrician is permitted to install, test
and replace the battery pack.
Follow the instructions in the separate "Battery pack"
installation and operating manual.
NOTE
Only a genuine battery pack from SOMMER
Antriebs- und Funktechnik GmbH may be
used.
INFORMATION
Commissioning is not supported if the
battery pack is the sole power supply.
Mains voltage is required for
commissioning the operator.
Installing and connecting battery pack
Fig. 1
1. Disconnect the operator from the mains voltage.
Check that the operator is disconnected from the
power supply.
Fig. 2
2. Unscrew the screws on the control unit housing and
remove the cover.
Fig. 3
3. Insert the battery pack into the provided position in
the side of the control unit. If necessary, fasten the
battery pack with adhesive strips, see the separate
"Battery pack" manual.
Fig. 4
4. Plug the connection cable into the battery pack and
into the battery pack slot in control unit circuit board.
5. Press the transmitter button to check the operator
function.
The operator is powered by the battery pack.
Operator opens or closes the door at reduced
speed.
6. Supply the operator with the mains voltage.
Check that the power supply is connected.
Unplugging and removing battery
The battery pack is removed in the reverse order, see
Chapter "11.10 Installing and removing battery pack",
section "Installing battery pack".
66


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Sommer S 9060 Tiga at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Sommer S 9060 Tiga in the language / languages: English as an attachment in your email.

The manual is 28,61 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Sommer S 9060 Tiga

Sommer S 9060 Tiga User Manual - German - 96 pages

Sommer S 9060 Tiga User Manual - Dutch - 96 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info