680825
53
Zoom out
Zoom in
Previous page
1/96
Next page
53
S10564-00001_Rev-A_EN
10. Connections and special functions of the carriage
WARNING
Risk of injury during automatic
closing!
Automatically closing doors can injure
people or animals in the movement area
of the door when the door is closing.
Serious injury or death may result.
Always keep the moving door in sight.
Persons or animals must not be in the
range of movement of the door.
Never put your hand near the door
or moving parts when it is moving.
In particular, do not reach into the
ceiling holder or the push arm.
Do not drive through the door until it has
been fully opened.
NOTE
If the door is not in view and the operator
is actuated, objects in the movement area
of the door may be jammed and damaged.
Objects must not be in the range of
movement of the door.
INFORMATION
The door opens completely if it hits an
obstacle.
INFORMATION
Operation with automatic closing must
comply with EN 12453. This is a legal
requirement.
National regulations must be observed in
non-European countries.
A photo eye must be connected.
Bridging the safety inputs with wire bridges
is not permitted.
10.16 Open holding time
The open holding time is the time during which the door
remains open after reaching the door OPEN end position
until it automatically closes.
During the open holding time, the request side, which
gave the open command, receives no light signal.
The open holding time is restarted after every additional
command.
Example: If a command is sent while the operator is
closing automatically, it opens completely and the open
holding time is reset.
INFORMATION
The open holding time set at the factory
is 30 seconds from the end position and
60 seconds from partial opening.
These values can be changed and set via
SOMlink and a WLAN-enabled device.
Values in the range of 10-240 seconds can
be selected for the open holding time.
The values are 1-255 seconds for partial
opening.
1. The open holding time of the door is 30 seconds.
Every new command within 30 seconds restarts the
open holding time. The door OPEN end position is
reached by pressing button 1 on the transmitter.
The door movement cannot be stopped with the
transmitter.
2. The door closes automatically after 30 seconds.
The closing movement can be stopped by a
command with the transmitter.
Door opens completely - after reversal of direction.
3. The door starts the closing process again after
30 seconds.
Door in door CLOSE end position.
INFORMATION
The factory setting is fully automatic
closing with a set open holding time of
30 seconds. The open holding time begins
after the door OPEN end position and the
partial opening end position are reached.
When driving through the photo eye,
the open holding time is shortened to
5 seconds.
This setting and the selection of semi-
automatic closing can be adjusted via
SOMlink and a WLAN-enabled device.
53


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Sommer S 9060 Tiga at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Sommer S 9060 Tiga in the language / languages: English as an attachment in your email.

The manual is 28,61 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Sommer S 9060 Tiga

Sommer S 9060 Tiga User Manual - German - 96 pages

Sommer S 9060 Tiga User Manual - Dutch - 96 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info