28530
40
Zoom out
Zoom in
Previous page
1/182
Next page
Simrad ER60 Operator manual
32
850-164692 / Rev.B
1 Move the reference target slowly around to record a
sufficient number of data points (>100) evenly distributed
inside the beam. Make sure that a reasonable number of
hits are made close to the center of the beam. This is
important in order to ensure a correct estimate for the Sa
correction parameter.
2 While moving the target you should keep the reference
target within the depth limits you entered in the Record
dialogue.
3 While moving the target and recording of data points
stops, the measured TS value may be outside the limits
enteredintheRecord dialogue.
4 Stop and restart recording as required by using the
Stop/Start command found in the Main menu. It is
recommended to stop collecting data if unwanted fish
echoes are entering into the depth window, and restart
again when disappeared
5 When you have finished data recording open the File
menu, choose Save As to open the Save As dialogue.
6 Choose the directory where you want the calibration file to
be saved, and enter a file name for your calibration file.
7 Click Save to finish.
The calibration program will now use two different models to fit
recorded data, a polynomial model and a beam model.
The Plot view will plot the model along with the recorded data
points. Blue circles indicate values below the model; red circles
indicate values above the model.
The green circles close to the centre axis indicate the points that
have been used when estimating the Sa Correction value.
In the View menu located on the menu bar you can control what
is shown in the Plot view. You can choose between results from
the polynomial model or the beam model. In the View menu you
can also choose the plot type for each of the two models. If you
choose the Polar command you will see a polar plot from
“above”. The other plot types are cartesian showing a slice
through the model. You may toggle between the plot types using
the space bar on your keyboard.
40


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Simrad ER60 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Simrad ER60 in the language / languages: English as an attachment in your email.

The manual is 3,03 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info