790195
48
Zoom out
Zoom in
Previous page
1/56
Next page
en Faults and what to do about them
48
The water is not draining. Drain pipe or water drain hose is blocked. Clean the drain pipe and the
water drain hose.
Drain pipe or water drain hose is caught or jammed. Ensure that the drain
pipe and the water drain hose are not kinked or trapped.
Could the drain pump be blocked?
~ "Drain pump is blocked" on page 42
Could the drain hose at the siphon be blocked?
~ "The drain hose at the siphon is blocked" on page 43
~~~ (Rinse hold = no final drain) is activated (depending on the
model). Continue the programme by selecting Spin/Drain and pressing
Start Reload .
The water drain hose is connected too high. Install the water drain hose at
a maximum height of 1 meter.
~ Page 16
Water is not visible in the
drum.
Not a fault – the water is below the visible area.
The wrong detergent/fab-
ric softener has been
poured into the dis-
penser(s).
Empty the dispenser(s), clean it/them and pour in the correct product.
~ "Emptying the detergent draw, cleaning the detergent drawer and its hous-
ing" on page 41
Detergent/fabric softener
has congealed in the dis-
pensers.
Empty the dispenser(s), clean it/them and pour in the correct product.
Foam is leaking from the
detergent drawer.
Too much detergent used?
Mix 1 tablespoon of fabric softener with ½ litre of water and pour into
dispenser II. (Not for outdoor, sports and down-filled textiles!)
Reduce detergent dosage for the next wash cycle.
Use commercially available low foam detergent and care product which are
suitable for machine.
Repeated, intensive foam-
ing.
Have you used too much detergent? Add less detergent in the next time you
run a wash cycle with the same load.
Detergent/fabric softener
drips off the seal and col-
lects on the door or in the
seal fold.
There is too much detergent/fabric softener in the dispensers. Do not fill the
dispensers above the max. mark.
The spin result is not sat-
isfactory.
Laundry wet/too damp.
Not a fault – the unbalanced load detection system has interrupted the
spin cycle because the laundry is unevenly distributed. Distribute small and
large items of laundry evenly in the drum.
Is Less Ironing additional programme setting selected (depending on the
model)?
Is Silent additional programme setting or Silent programme selected
(depending on the model)?
Is the selected speed too low?
Faults Cause/Remedy
48


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Siemens WN44G290GB at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Siemens WN44G290GB in the language / languages: English as an attachment in your email.

The manual is 2.53 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info