693647

Siemens Climatix 2 Manual

56
Zoom out
Zoom in
Previous page
1/77
Next page
INSTRUCTION MANUAL OF THE SIEMENS CLIMATIX 2 CONTROL EQUIPMENT
-
56
-
The Switch ON delay parameter defines the delay time of turning on of the substitute unit after the
boiler is put out of operation or turned off.
The setting of the Switch ON delay parameter is ranging from 0 – 60 min; the default value is 1
min.
The instructions for changing this parameter can be found in chapter 4.
The selection Substitute operation (OFF/ON/Auto) enables to connect the contact for the
substitute unit manually.
The default value is Auto. The instructions for changing this parameter can be found in chapter 4.
7.9. SENSOR CALIBRATION
The function Sensor calibration enables to correct the measured values:
- outside temperature (B9)
- temperature in the reference room HC1 (A6)
- temperature in the reference room HC2 (A7)
and to unify these temperature values which are shown on the display with other (more accurate)
measuring instruments which are used in that particular room.
The setting of these parameters is ranging from -3 to +3 °C; the default value is 0 °C.
The instructions for changing this parameter can be found in chapter 4.
7.10. LANGUAGE
The function enables to select the language of the communication between the control equipment
and the operator. In this program the version Czech and English languages are available.
The instructions for changing this parameter can be found in chapter 4.
7.11. OPERATING HOURS
The line Operating hours informs about the total time of the boiler operation. After clicking on this
line the value can be zeroed if it is necessary.
7.12. IP CONFIGURATION
This menu can be accessed only after entering the service password (see chap. 5.24.). This
function is used for setting the communication with the control equipment via the Internet – see
chap. 9.3.
… 56 …


Need help? Post your question in this forum.

Forumrules
1

Forum

siemens-climatix-2

Reset search

  • salve
    chiedo se è possibile fare un by pass per far partire il sistema di condizionamento a causa dell'oscuramento :del controllore POL/STD
    grazie
    Submitted on 11-3-2022 at 12:44

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Siemens Climatix 2 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Siemens Climatix 2 in the language / languages: English as an attachment in your email.

The manual is 1,35 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info