770386

Sharp K-62V19IM1 Manual

21
Zoom out
Zoom in
Previous page
1/110
Next page
EN -12-
bears no liability of any kind for da-
mage and loss arising from not
complying with safety standards!
The instructions given below must be
followed without fail during wiring :
The earthing cable must be connected
via the screw with the earthing mark.
Supply cable connection must be as
shown in Figure 6. If there is no earthed
outlet conforming to regulations in the
installation environment, call the Autho-
rized Service immediately.
The earthed outlet must be in close vici-
nity of the appliance. Never use an ex-
tension cord.
The supply cable should not contact the
product’s hot surface.
In case of any damage to the supply
cable, make sure to call the Authorized
Service. The cable must be replaced by
the Authorized Service.
Wiring of the appliance must be per-
formed by the Authorized Service.
H05VV-F type supply cable must be
used.
Faulty wiring may damage the applian-
ce. Such a damage will not be covered
under the warranty.
The appliance is designed to connect
to 220-240V~ electricty is different than
the value given above, call the Authori-
zed Service immediately.
The Manucaturer Firm declares that its
bears no responsibility whatsover for
any kind of damage and loss arising
from not complying with safety norms!
WIRING AND SAFETY OF THE
BUILT-IN COMBINED OVEN
Wiring of the appliance must be per-
formed by the Authorized Service. The
appliance is designed to connect to 220-
240V~ and 380-415V 3N ~ electricity. If
the mains electricity is different than the
value given above, call the Authorized
Service immediately. Connection
of the appliance must be as shown in
Figure 6. The appliance is designed for
xed connection to the mains. There is
to install an all pole disconnector inside
they supply circuit with a contact open-
ning of at least 3mm ( rated 63A, delay
functioning type ).
Figure 6
For models over 9500W, wires with a diameter of
2
3x4.0 mm must be used.
2
3x2.5mm 220V~
2
3x2.5mm 230V~
2
3x2.5mm 240V~
2
5x1.5mm 380V~, 3N~
2
5x1.5mm 400V~, 3N~
2
5x1.5mm 415V~, 3N~
… 21 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Sharp K-62V19IM1 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Sharp K-62V19IM1 in the language / languages: English, German, French, Italian as an attachment in your email.

The manual is 6.14 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info