770386

Sharp K-62V19IM1 Manual

20
Zoom out
Zoom in
Previous page
1/110
Next page
EN -11-
Insert the oven into the cabinet by pus-
hing it forward. Open the oven door and
insert 2 screws in the holes located on
the oven frame. When the product fra-
me touches the wooden surface of ca-
binet, tighten the screws.
Worktop
min.
25 mm
min.
50 mm Built-in hob
Built-in oven
If the oven is installed under a hob, the
distance between the worktop and the
top panel of the oven must be a mini-
mum of 50 mm and the distance bet-
ween the worktop and the top of control
panel must be a minimum of 25 mm.
The dimensions and material of the ca-
binet in which the oven will be installed
must be
correct and resistant to increases in
temperature. In a correct installation,
contact with electrical or insulated parts
must be prevented. Insulating parts
need to be tted in a way to ensure that
they cannot be removed by using any
kind of tool. Installing the appliance in
the close vicinity of a refrigerator or a
deep-freezer is not recommended. Ot-
herwise, the performance of the above-
mentioned appliances will be negatively
affected due to emanating heat. After
removing your oven from its packaging,
be sure that the oven is not harmed. In
case, you suspect of any damage to
the appliance, do not use it; immeditely
contact Authorized Service.
POSITIONING THE BUILT-IN
HOB
In order to prevent leakage of any li-
quids on the counter, a special sealing
putty is supplied
together with your oven. Apply tihs putty
around the clearance on the kitchen co-
unter,
measured in the size indicated in the
Figure 2. Extend the ve-piece putty
by stretching and apply it around the
clearance. Place the hob on it, with its
control buttons being on the right side.
Make sure to t the clamps as shown
in the Figure 3. After tting your hob
into its place, neatly remove the excess
sealing putty around the sides with the
help of a spatula(Figure 3).
In case the thickness of the kitchen co-
unter is less than 40mm, use the clamp
as shown in the Figure 4. Place your
hobs directly into the opening gap( Fi-
gure 5a-5b)
520mm
590mm
560mm
150mm
Min.60mm
490mm
Min.50mm
Figure 5b
–Faulty wiring may damage the appli-
ance. Such damage will not be cove-
red under the warranty.
–The appliance is designed to connect
to 220-240V~. If the electricity is diffe-
rent than the value given above, call
the Authorized Service Centre imme-
diately.
The manufacturer declares that its
… 20 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Sharp K-62V19IM1 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Sharp K-62V19IM1 in the language / languages: English, German, French, Italian as an attachment in your email.

The manual is 6.14 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info