753086

Sentiotec wave.com4 11 kW Manual

13
Zoom out
Zoom in
Previous page
1/308
Next page
EN
Instructions for installation and use p. 13/38
4. Installation
During installation observe the technical data; see Page 37:
4.1. Installing the power unit
See Fig. 2 on Page 14.
ATTENTION!
Damage to the unit
The sauna controller is resistant to splashing water, but direct contact with water
could still damage it.
●Install the sauna controller in a dry place where the maximum humidity will
not exceed 95%.
●When installed in the sauna cabin, the cable bushings must not point upwards!
●The sensors may only be connected using the sensor cables supplied
with the unit, which are heat-resistant up to 150 °C.
●The heater sensor cables may NOT be longer than 10 m.
●Outside the cabin, the sensor cables can be extended using cables
that are not temperature-resistant.
ATTENTION!
Interference can impair signal transmission
●Route all sensor cables separately from other mains cables and control cables.
●Protect cables with only one layer of insulation by using a conduit (double
insulation).
To install the power unit 1, carry out the following steps:
1. Takeo󰀨thecoverofthepowerunit.
2. You can fasten the power unit to the supporting surface at the 4 corners of
the chassis (see arrows Fig. 4 on page 17)
4.2. Installing the main switch
Follow the operating instructions for the switch.
4.3. Installing the cabin light and the light switch
Follow the operating instructions for the switch.
… 13 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Sentiotec wave.com4 11 kW at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Sentiotec wave.com4 11 kW in the language / languages: English, German, Dutch, French, Italian, Swedish, Finnish as an attachment in your email.

The manual is 10,9 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info