753086
15
Zoom out
Zoom in
Previous page
1/308
Next page
EN
Installation instructions, only for experts p. 15/38
4.6. Installing the heater sensor F1 with overheat cut-out
Note the following points when installing the heater sensor:
The heater sensor must be installed in the sauna cabin above the middle of
the sauna heater. For cabins up to 2 × 2 m a distance of 19 cm from the cabin
wall must be maintained, for larger cabins a distance of 35 cm.
Theheatersensormustbeinstalledinsuchawaythatitisnota󰀨ectedby
inowingair.
Fig. 3: Installing the sensor
To install the heater sensor, carry out the following steps (see Fig. 3):
1. Drill through the cabin ceiling with an 8 mm bit.
2. Pull the two 2-core heater sensor cable through the hole.
3. Fasten the sensor housing using the wood screws supplied.
4. Guidethetwo2-coreheatersensorcablesuptothepowerunitandx
the heater sensor cables with cable clamps.
5. Checkthattheheatersensorisrmlyfastened.
Take care not to damage any of the sensor cables when pulling them in.
19 cm
35 cm
> 2 × 2 m
< 2 × 2 m
150 cm
F1
WC4-H-H
15


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Sentiotec wave.com4 11 kW at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Sentiotec wave.com4 11 kW in the language / languages: English, German, Dutch, French, Italian, Swedish, Finnish as an attachment in your email.

The manual is 10,9 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info