332166
23
Zoom out
Zoom in
Previous page
1/72
Next page
GB
23
*
SUITABLE
UNSUITABLE
Cast iron
Enamelled steel
Special stainless steel
Copper,
Aluminium, Glass, Earthenware,
Ceramic, non magnetic Stainless steel
Practical advice on using the appliance
! Use cookware made from materials that are
compatible with the induction principle
(ferromagnetic material). We especially recommend
pans made from: cast iron, coated steel or special
stainless steel adapted for induction. Use a magnet
to test the compatibility of the cookware.
In addition, to obtain the best results from your hob:
Use pans with a thick, flat base to fully utilise the
cooking zone.
Always use pans with a diameter that is large
enough to cover the hotplate fully, in order to use
all the available heat.
Make sure that the base of the cookware is
always dry and clean, to fully utilise and extend
the life of both the cooking zones and cookware.
Avoid using the same cookware that has been
used on gas burners: the heat concentration on
gas burners may distort the base of the pan,
causing it not to adhere correctly.
Safety devices
Pan sensor
Each cooking zone is equipped with a pan sensor
device. The hotplate only emits heat when a pan
with suitable measurements for the cooking zone is
placed on it.
If the indicator light is flashing, it may indicate:
An incompatible pan
A pan whose diameter is too small
The pan has been removed from the hotplate.
Residual heat indicators
After the pan has been removed from one of the
cooking zones, part of the power level indicator will
flash while the temperature of that particular zone
remains above 60°C. This reduces the risk of burns
and scalds.
Overheating protection
If the electronic components overheat, the hob
switches off automatically and the power level
indicator will show the two external parts or the two
internal and the two external parts as active. When
the temperature has reached a more appropriate
level, this message disappears and the hob may be
used again.
Safety switch
The appliance has a safety switch that automatically
switches off the cooking zones when they have been
in operation for a certain amount of time at a given
power level. When the safety switch has been
triggered, the display shows 0.
For example: the right rear hotplate is set to 5 and
will switch off after 3 hours of continuous operation,
while the front left hotplate is set to 2 and will switch
off after 10 hours.
Buzzer
Can also indicate several irregularities:
An object (a pan, cutlery, etc.) has been placed
on the control panel for more than 10 seconds.
Something has been spilt on the control panel.
A button has been pressed for too long.
All of the above situations may cause the buzzer
to sound. Remove the cause of the malfunction to
stop the buzzer. The control panel locks
automatically in the above situations. To unlock it
press the [key icon] button, the settings will have
been maintained. If the cause of the problem is
not removed, the buzzer will keep sounding and
the hob will switch off.
23


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Scholtes til 642 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Scholtes til 642 in the language / languages: English, German, Dutch, French, Italian as an attachment in your email.

The manual is 3,04 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info