24757
11
Zoom out
Zoom in
Previous page
1/32
Next page
The MDR16’s input channels nine through sixteen are STEREO or DUAL
MONO. These channels can be used for stereo inputs, or, since they have
separate faders for left and right, they can be used as dual mono inputs.
The equalizers and auxiliary are set up vertically as shown in the follow-
ing diagram.
The following section details each part of the MDR16’s STEREO/DUAL
MONO INPUT CHANNELS including the 2-BAND EQ, AUX sends, PAN and
LEVEL controls. The input channels nine through sixteen on the MDR16
feature high quality, discrete transistor pre-amp providing transparency
and extended dynamic range. These inputs feature a combie (combina-
tion) connector which can accept a standard XLR mic cable for micro-
phone level signals, or a standard 1/4" phone cable, either balanced (TRS
TIP/ RING/SLEEVE) or unbalanced (TS – TIP/SLEEVE) for line level signals.


















































 


 















 








 





















Controls and Functions
9
(MONO INPUT CHANNEL CONTINUED)
SOLO Switch
When engaged, the yellow LED illuminates, indicating the input channel is assigned
to the SOLO bus. The SOLO switch activates a logic control switch. Pressing the switch
repeatedly will assign the input channel on or off the SOLO bus. You can use the SOLO
LEVEL control to adjust the overall volume to the SOLO Bus.
1/2 OUTPUT Switch
The 1/2 switches are used to assign the channels to the
1/2
stereo bus. Any channels
that have the
1/2
switch pressed in (the green LED is on) will be heard in the
1/2
out-
puts. In recording applications, you can use
1/2
switches with left and right panning to
assign a channel to either the 1 or 2 bus outputs for sending to an input of a recorder.
You can also mix the 1/2 bus with the LEFT and RIGHT mix bus by using the 1/2 to MIX
switch, located in the master section above the 1 / 2 OUTPUTS faders, allowing you
to subgroup channels. In this mode, you can assign channels to the
1/2
bus and use
the
1/2
OUTPUT faders to sub-mix those channels. More information on the
1/2
to MIX
switch can be found later in this manual.
3/4 OUTPUT Switch
The 3/4 switches are used to assign the channels to the 3/4 stereo bus. Any channels
that have the 3/4 switch pressed in (the red LED is on) will be heard in the 3/4 outputs.
In recording applications, you can use 3/4 switches with left and right panning to
assign a channel to either the 3 or 4 bus outputs for sending to an input of a recorder.
You can also mix the 3/4 bus with the LEFT and RIGHT mix bus by using the 3/4 to MIX
switch, located in the master section above the 3 /4 OUTPUTS faders, allowing you to
subgroup channels. In this mode, you can assign channels to the 3/4 bus and use the
3/4 OUTPUT faders to sub-mix those channels. More information on the 3/4 to MIX
switch can be found later in this manual.
FADER
The MDR16’s 60mm input FADER controls the overall channel level. The input FADER
features an audio taper and no detents for smooth fades.




















12
13
14
STEREO - DUAL/MONO INPUT CHANNEL SECTION
15
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Samson MDR16 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Samson MDR16 in the language / languages: English as an attachment in your email.

The manual is 12,31 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info