512484

Robomow Tuscania 500 Manual

90
Zoom out
Zoom in
Previous page
1/268
Next page
EN
36
Mon 15:34
Next: Tue 13:00
Current Day and Time
Next Scheduled Start
(Day and Time)
Battery icon
Mon 15:34
Next: Tue 13:00
Mon 15:34
Next: Tue 13:00
Mon 15:34
Next: Tue 13:00
Current Day and Time
Next Scheduled Start
(Day and Time)
Battery icon
Displayed when there is no weekly
program or when it is set to ‘off’
Displayed when a program is set
Figure 3.1
Charging in the
Base Station
ChargingChargingCharging
Ready
keep charging
Ready
keep charging
Figure 3.2
LCD display during
charging process
Figure 3.3
LCD display during while
battery if fully charged
Non-Base Station Zone
–
When Robomow has operated the allotted time, it is required to Press the Stop button and to drive
it back to the Base Station for charging, otherwise Robomow will start follow the perimeter wire to
search for the Base Station.
If Robomow has completed its mowing and it is more than 15 minutes before you arrive to move it,
the LCD screen will be blank. Robomow will shut itself down into a sleep mode after 15 minutes of
inactivity at all times. This is an energy saving feature. Pressing the
‘GO’ button will wake it up and
display the message that was on the LCD when it went into sleep mode.
3.9 Charging
Robomow is supplied with two power supplies:
1.
Base Station Charger –
- It is connected between the Base Station and a 230V/120V wall socket. It is connected to the
wall socket via an integrated power cord and to the Base Station via a 15m / 50ft long low
voltage cable (the length of the low voltage cable must not be lengthened).
- It is approved for outdoor use.
- The charging time is approximately 20 hours, depending on conditions.
- When the mower is in the Base Station the battery is charged and one of the following screens
is displayed:
- The charging system and battery are designed to remain plugged in at all times of non-use,
throughout the mowing season, without concern to over charging, over heating or damaging the
battery.
2. Winter Charger -
- During long period, such as winter, when Robomow is not in use, it is recommended to clean
Robomow and connect it to charging using the winter charger to all the period it is not in use
(refer to paragraph 5.7 – Winter Storage).
- The winter Charger is an integrated part of the Robomow and it is designed for indoor dry use
only.
Do not charge Robomow where wet contact is likely.
- Never connect the winter charger while Robomow is still in the Base Station.
- The charging time is approximately 48 hours when using the winter charger.
- When connecting the charger the following message (figure 3.2) will be displayed and the
battery icon will continually move from empty to full to show the charging.
- Once the battery is fully charged, the message will change to that as shown in Figure 3.3,
reminding you to keep it connected to the charger until the next use.
Mowing
Press GO
Mowing
Press GO
Mowing
Press GO
… 90 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Robomow Tuscania 500 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Robomow Tuscania 500 in the language / languages: English, German, Dutch, French, Italian as an attachment in your email.

The manual is 9,61 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info