625561
24
Zoom out
Zoom in
Previous page
1/46
Next page
NX SERIES V0913 23
English
Mounting of the saw blade (g.7)
1 Slide away the table.
2 Open the lower saw blade cover plate (1).
3 Raise the saw blade to the highest point.
4 Now put the locating pin (3) in the saw table to block the saw arbor.
5 Tighten the saw nut with the hookspanner (4). Warning: left hand threaded saw arbor!
6 Do not forget to remove the pin which holds the saw arbor in place while tightening the nut.
Fig.7
Mounting of the scoring blade
Attention: for the changing of the main saw blade or the saw blade of the scoring unit,
disconnect the main switch en put the button on the « O » position.
In order to put, or change the scoring saw blade, slide the table to the rear far end and open the lower
saw blade cover.
This cover is equipped with a safety switch which prevents the motors from being started up.
Turn the scoring arbor to the left (see gure below 2) and put the spanner on the at sided arbor.
Put the Allen key into the bolt and loosen the bolt.
Make sure both scoring blade and saw arbor ange are clean!
Put the blade and tighten the bolt and close the cover.
24


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Robland NXSD 310 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Robland NXSD 310 in the language / languages: English as an attachment in your email.

The manual is 1,93 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Robland NXSD 310

Robland NXSD 310 User Manual - German - 100 pages

Robland NXSD 310 User Manual - Dutch - 100 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info