625561
25
Zoom out
Zoom in
Previous page
1/46
Next page
24 V0913 NX SERIES
English
Scoring saw blade adjustments
The horizontal and vertical adjustments of the scoring saw blade are made as follows: put the Allen key
in the opening in the table as shown on the picture: for raising or lowering scoring saw blade, turn the
Allen key (1) in direction of the clock. To lower it, turn anti-clockwise. The horizontal shift of the scoring
blade is made in the same way: in the direction of the clock to move it to the left , in the other direction
to move it to the rear (right). These adjustments are positive and don’t need any blocking.
Aligning the scoring unit in aspect of
the main saw blade
It’s recommended to use a double blades scoring saw blade, which can be used with spacers, allowing
you to adapt the thickness to different kerfs and align it properly with the main saw blade. To achieve a
perfect cut, without chipping or tear-out, it is necessary to perfectly align the scoring unit with the main
saw blade.
Check the main saw blade kerf and put spacer rings between the scoring saw blade halfs in order to
obtain the same kerf.
To check the cutting result, cut a sample piece, and check the result.
The pictures below show you the different possibilities:
1 The scoring saw blade is set too low: you will have some tear-out on the underside of the work
piece.
2 The scoring unit is set too high and cuts too deep, or is too wide: you will have a chamfered edge
on both sides.
3 The scoring unit is not perfectly aligned to the main saw blade, you will have some overflow on
one side and some tear-out on the other side.
4 The scoring unit is perfectly aligned in aspect of the main saw blade, a smooth perfect clean
sharp cut.
It is recommended to set the height of the scoring saw blade as minimal as possible in order to only cut
the upper layer or coating of the panel. When the scoring saw blade is not used over a longer period of
time, we recommend the remove it and store it in a dry place.
25


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Robland NXSD 310 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Robland NXSD 310 in the language / languages: English as an attachment in your email.

The manual is 1,93 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Robland NXSD 310

Robland NXSD 310 User Manual - German - 100 pages

Robland NXSD 310 User Manual - Dutch - 100 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info