520097
86
Zoom out
Zoom in
Previous page
1/119
Next page
86
Flap Setting (
CAMBER FLAP
)(
GLID
):
CAMBER FLAP
assigns the primary flap control [defaults to VR(A)] to allow
trimming in ight of the ap action.
The up/down travel of each flap (camber flaps:
FLP1
/
2
) can be adjusted
independently. Also the center position of ap servo can be offset.
NOTE: If
FLAP-TRIM
is activated, you can not use
CAMBER FLAP
function
simultaneously.
[Note] When changing the polarity of a rate, "change rate dir?" is displayed for a check. Please set up after
pressing DIAL for 1 second and canceling an alarm display.
GOAL of EXAMPLE: STEPS: INPUTS:
Ex: Set the maximum travel of
35
% of
the total ap travel.
Open the
CAMBER FLAP
function.
for 1 second.
(If
BASIC
, again.)
C
to
CAMBER FLAP
.
Adjust the up/down trim amount
separately.
(Ex: adjust to
35%
.)
C
to
FLP1
. VR(A). to
35%
.
VR(A). to
35%
. Repeat.
Option: Adjust the center position of
ap servo.
C
to
CENTER
. to desired point.
Close menu.
Adjustability:
Rate: -100% to +100%, with a default of +30%
Center position (
CENTER
): The operation reference point of ap can be offset. -100% to +100%, with a default of 0%.
86


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Robbe Futaba FF-10 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Robbe Futaba FF-10 in the language / languages: English as an attachment in your email.

The manual is 1,72 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Robbe Futaba FF-10

Robbe Futaba FF-10 User Manual - German - 92 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info