692210
57
Zoom out
Zoom in
Previous page
1/64
Next page
57
Cleaning the inside of the nozzle
Heat the nozzle. Load/remove the lament until the lament ows normally.
If the nozzle does not eject enough lament, let the nozzle cool down to the melting temperature stated by
the lament manufacturer (the lament must be viscous) and carefully extract the lament until it has been
removed from the extruder (including impurities). Cut off the contaminated part from the lament and reload
it after the nozzle has heated up again.
c) Cleaning the inside of the extruder
For details, download the "Cleaning and maintenance" booklet from www.conrad.com/downloads, or scan the QR
code on page 5. Follow the instructions on the website.
d) Cleaning the print bed
Carefully remove residues from the print bed using the scraper.
e) Removing the lament
Ensure that the nozzle temperature is not higher than 170 °C.
If the lament is metal or wood, cut through it, replace it with a PLA lament, and then remove the PLA
lament. The PLA lament will eliminate any residues from the wood or metal lament.
f) Storing the 3D printer
Remove the lament.
Move the on/off switch to the O position and disconnect the 3D printer from the power supply. Allow it to cool down
to room temperature.
Clean the 3D printer if you do not plan to use it for an extended period.
Store the 3D printer in a dry, dust-free location out of the reach of the children.
57


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Renkforce RF100 XL plus at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Renkforce RF100 XL plus in the language / languages: English as an attachment in your email.

The manual is 7,94 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Renkforce RF100 XL plus

Renkforce RF100 XL plus User Manual - German - 62 pages

Renkforce RF100 XL plus User Manual - Dutch - 64 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info