692210
56
Zoom out
Zoom in
Previous page
1/64
Next page
56
By default, the printer is controlled via your computer when the rmware update is complete. If you wish to control
the printer via the control panel and print from the SD card, enable "Control the 3D printer via the control panel"
and set the print source:
- Go to the < ReadyPrint > main menu and select < Setting > to open the < Set > menu.
- Select < SelectSource > from the < Set > menu, and then select < 115200 >.
Go back to the < ReadyPrint > menu.
Restart the 3D printer.
Two les and a folder are saved to the SD card during the update process. Delete these les (e.g. on your computer).
These les cannot be deleted via the control panel (only via your computer).
Delete these les immediately after the update, otherwise the next update may not install properly.
18. Cleaning and maintenance
Do not use aggressive detergents, rubbing alcohol or other chemical solutions, as these could damage the
casing or even impair the functioning of the product.
Never immerse the printer in water.
Burn hazard! Never touch the hot nozzle with bare ngers.
a) Cleaning the printer
Use a dry, soft cloth or a brush to clean the exterior of the 3D printer.
b) Cleaning the nozzle
Cleaning the outside of the nozzle
Use a dry, soft cloth or other similar material to wipe the nozzle after each print.
The nozzle must still be hot. If this is not the case, heat the nozzle before cleaning it.
56


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Renkforce RF100 XL plus at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Renkforce RF100 XL plus in the language / languages: English as an attachment in your email.

The manual is 7,94 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Renkforce RF100 XL plus

Renkforce RF100 XL plus User Manual - German - 62 pages

Renkforce RF100 XL plus User Manual - Dutch - 64 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info