692210
58
Zoom out
Zoom in
Previous page
1/64
Next page
58
19. Troubleshooting
Problem Possible solution
The 3D printer does not switch on. The
touchscreen display and printer light do
not turn on.
Check that the mains cable is connected properly.
Check the mains socket. Is it supplied with electricity?
You cannot establish a USB connection
with the 3D printer.
Check that the USB cable is connected.
Have you selected the correct USB port in the software?
Are the required drivers installed?
Disconnect and then reinsert the USB cable.
Switch the 3D printer off, and then switch it back on.
Restart your computer.
Use a different USB port on your computer.
Connect the 3D printer directly to a USB port on your computer. Do
not use a USB hub.
The printed object is defective.
Check the nozzle temperature settings. These must be suitable for
the lament material and printed object. Experiment with several
temperature settings.
Do not start printing until the nozzle has reached the required
temperature.
Decrease the distance between the print bed and nozzle (see “a)
Calibrating the print bed” on page 29).
When printing via your computer, avoid using other programs that
require a lot of computing power. Virus scanners and downloads can
affect the transfer of data to the 3D printer. Try printing the same model
via the SD card to check that the USB connection is not the cause of
the problem.
Remove excess lament from the nozzle before each print.
The ow of lament stops, or there is not
enough lament material.
Check the lament spool. It must be able to rotate easily.
Check whether the lament material has become trapped or wrapped
around the spool/spool holder.
Check that the lament was inserted correctly over the lament spool.
Check whether the nozzle temperature is too low for the lament
material.
Check whether the nozzle is blocked. If necessary, clean the nozzle
(see “b) Cleaning the nozzle” on page 56 for details).
58


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Renkforce RF100 XL plus at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Renkforce RF100 XL plus in the language / languages: English as an attachment in your email.

The manual is 7,94 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Renkforce RF100 XL plus

Renkforce RF100 XL plus User Manual - German - 62 pages

Renkforce RF100 XL plus User Manual - Dutch - 64 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info