726821

REMKO RVS DC serie 50-80-130-180 Manual

21
Zoom out
Zoom in
Previous page
1/44
Next page
Selecting the installation location
The unit is designed for horizontal
installation on a base in outdoor
areas. The installation site must be
level, flat and firm. The unit should
also be secured to prevent it from
tipping over.
For external installation, please
observe the following instructions
to protect the unit from
the influence of the weather.
It is also possible to install
the unit in the interior of
the building. However, in this case
the circulation of the required air
flow volume (see technical data)
must be assured. Any change
to the air flow volume can result
in faults or damage to the unit.
Rain
The unit should be at least 10 cm
off the ground when mounted on
the roof or ground.
Sun
The finned condenser gives
off heat in cooling mode.
Exposure to sunlight further
increases the temperature of
the fins and reduces the heat
released by the finned heat
exchanger.
The unit should, whenever
possible, be installed on the north
side of the building.
If necessary, take measures
to provide sufficient shade
(responsibility of customer).
This could be a small roof.
However, the discharging warm
air flow must not be affected by
the measures.
Wind
If the unit is being installed
inwindy areas, ensure that
the warm outlet air is discharged
in the prevailing wind direction.
If this is not possible, it may be
necessary to install a windbreak
on-site (Figure 3).
Ensure that the windbreak does
not adversely affect the air intake
to the unit.
20 cm
Snow
2 Minimum clearance to snow
Snow
The unit should be wall-mounted
in areas of heavy snowfall.
Installation should be at least
20 cm above the expected
level of snow to prevent snow
from entering the outdoor unit
(Figure 2).
Wind
3 Windbreak
Warm air
Cold
fresh air
Light well
Chiller
Warm air
Light well
Additional
fan
4 Installation inside buildings (cooling mode)
Sun
The finned condenser gives off
heat in cooling mode.
Exposure to sunlight further
increases the temperature
of the fins and reduces the heat
released by the finned heat
exchanger.
Cooling capacity changes as
a consequence of ambient
conditions influenced by rain, sun,
wind, and snow, for example.
NOTE
21
… 21 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for REMKO RVS DC serie 50-80-130-180 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of REMKO RVS DC serie 50-80-130-180 in the language / languages: English as an attachment in your email.

The manual is 3,08 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of REMKO RVS DC serie 50-80-130-180

REMKO RVS DC serie 50-80-130-180 User Manual - German - 44 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info