587581
19
Zoom out
Zoom in
Previous page
1/28
Next page
Installing the unit
Installation
Installation should only be
performed by authorised
specialists.
NOTE
The indoor unit is installed by
taking into account the position of
the air outlet. This can be at the
top or bottom as well as at the
sides.
1. Use the unit dimensions to
mark the fixing points on
structural parts approved to
support the static load.
2. Open the display cover(Fig 6)
and remove the four screws
below the filter(Fig 7).
3. Dismantle the front of the unit:
lift up the front near the lower
part of the body by approx. 10
cm and fold it upwards (Fig 8).
4. Detach the front cover
connector by pulling it off the
circuit board (Fig 9).
5. If necessary, remove the break-
outs on the housing.
6. Fit the unit to the wall.
7. Connect the refrigerant
pipes, electrical cables and
condensation pipe to the indoor
unit as described below.
8. Check that the unit is level.
9. Re-assemble the unit.
6
Open the display cover
7
Remove the screws
8
U
ndo the front of the unit
9
Pull off the connector
The unit is factory filled with
dry nitrogen to check for leaks.
The pressurised nitrogen is
released when loosening the
union nuts.
CAUTION
Connecting the refrigerant
pipes
The connections to the refrigerant
pipes are made at the rear of the
unit (responsibility of customer).
It may be necessary to fit a reducer
or flared adapter to the indoor
unit.
These fittings are included as
standard.
Once installed, the connections
should be made tight against
vapour diffusion.
19
19


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for REMKO ATY351 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of REMKO ATY351 in the language / languages: English as an attachment in your email.

The manual is 1,65 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of REMKO ATY351

REMKO ATY351 Additional guide - German - 1 pages

REMKO ATY351 User Manual - German - 28 pages

REMKO ATY351 User Manual - Dutch - 28 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info