587581
21
Zoom out
Zoom in
Previous page
1/28
Next page
Electrical connection
A protected mains supply and
control cable should be connected
to the outdoor component and
indoor unit respectively.
All electrical installation
work should be performed
by specialist contractors.
Isolate the voltage supply
when connecting the electrical
terminals.
CAUTION
We recommend that customers
install a main/repair switch
in the vicinity of the outdoor
component.
The terminal blocks for making
the connections are located at
the rear of the unit. When the
unit is installed, measurements
can be made from the front by
removing the cover.
If an optional condensation
pump is used in conjunction
with the unit, it may be
necessary to install an
additional relay with a higher
contact rating after the switch-
off contact on the pump to
switch off the compressor.
Connecting the indoor unit
Make the connection as follows:
1. Dismantle the front of the unit
as described in the chapter
"Installing the unit".
2. Select the cable cross-section
according to the relevant
standards.
3. Connect the mains supply to
the unit and the control cable
to the outdoor component
(see electrical connection
diagram).
4. Re-assemble the unit.
Connecting the indoor unit
Terminal block/
control block
Mains cable
21
Electrical connection diagram
ATY 261 / ATY 351
Indoor unit Outdoor
component
Mains cable
Neutral conductor
Phase conductor
Earth conductor
230 V, 1~,
50 Hz,
L1 / N / PE
Control conductor
Compressor
PE
PE
N
1
N
L
L
N
L
N
L1
2
21


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for REMKO ATY351 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of REMKO ATY351 in the language / languages: English as an attachment in your email.

The manual is 1,65 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of REMKO ATY351

REMKO ATY351 Additional guide - German - 1 pages

REMKO ATY351 User Manual - German - 28 pages

REMKO ATY351 User Manual - Dutch - 28 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info