738868

Protector AS-7000 Manual

33
Zoom out
Zoom in
Previous page
1/88
Next page
Testing the function of the roller
shutter sensor
• Slowly move the roller shutter to the open position,
then the green LED on the roller shutter sensor (OPEN)
will flash briefly before the open position.
• Close the roller shutter, then the red LED (CLOSED)
will flash briefly.
Instructions for attaching the
stove transmitter
AS-T30 (figures 15 and T)
NOTE
The stove should be switched off and cool in order to
avoid burns to your skin.
The thermal sensor (figure 3) is fed into the exhaust
pipe through a hole and screwed to the stove pipe using
the included mounting bracket. The stove transmitter
should not be covered by cladding as this impedes the
radio signal and reduces the range.
1. Drill a 4 mm hole in a suitable position in the exhaust
pipe for the thermal sensor. If possible ensure that the
hole is positioned in such a way that the thermal sensor
cannot be seen after attachment.
2. Slide the mounting bracket over the thermal sensor
but do not tighten the screw to attach the thermal
sensor yet.
3. Insert the thermal sensor as far as possible into the hole
that you have drilled for it.
4. Move the mounting bracket on the thermal sensor
until it is lying on the exhaust pipe and then mark the
two attachment holes on the mounting bracket with a
suitable pen. Then remove the thermal sensor and the
mounting bracket from the exhaust pipe again.
5. Drill 2 mm holes at the two positions you have marked
for mounting on the exhaust pipe.
NOTE
If you have a double-walled exhaust pipe then take
care to drill the mounting holes only through the
outer pipe.
6. Fix the mounting bracket to the exhaust pipe by
screwing it with the two included tapping screws and
the two drilled holes as described above.
7. Now feed the thermal sensor through the mounting
bracket as far as possible and fix it to the mounting
bracket using the side screw. Do not tighten the screw
too far to avoid damage to the thermal sensor.
8. Lay the wire to the stove transmitter.
9. Connect the wire on the thermal sensor to the stove
transmitter and the wire marked in red to the screw
ROT / RED and the wire marked in black to the screw
SCHWARZ / BLACK.
EN
33
AS 7000_1.Vers. 2017 Manual 3xAA@150x180.indd 33 07.06.17 18:37
… 33 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Protector AS-7000 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Protector AS-7000 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 2,91 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info