722005

Pride Colt Deluxe 2.0 Manual

38
Zoom out
Zoom in
Previous page
1/44
Next page
38
Mid-size Scooter Series
WARNING! Ensure that the axle key is properly installed into the axle slot when mounting
the wheel. If not installed securely, the braking system is disengaged which may cause
personal injury and/or product damage may result.
10. Reinstall the drive wheel nuts and washers onto the axle and tighten.
WARNING! Make sure that both the nuts and washers are reinstalled and tightened
properly.
11. Inflate tires to the pressure in psi/bar/kPa indicated in each tire.
12. Remove the blocks from beneath the scooter.
EXTERIOR SURFACES
Bumpers, tires and trim can benefit from an occasional application of a rubber or vinyl conditioner.
WARNING! Do not use a rubber or vinyl conditioner on the scooter’s vinyl seat or tire
tread, as this may cause them to become dangerously slippery.
CLEANING AND DISINFECTION
Use a damp cloth and mild, non-abrasive cleanser to clean the plastic and metal parts of your scooter.
Avoid using products that may scratch the surface of your scooter.
If necessary, clean your product with an approved disinfectant. Make sure the disinfectant is safe for
use on your product before application.
WARNING! Follow all safety instructions for the proper use of the disinfectant and/or
cleaning agent before applying it to your product. Failure to comply may result in skin
irritation or premature deterioration of upholstery and/or scooter finishes.
BATTERY TERMINAL CONNECTIONS
Make certain that the terminal connections remain tight and uncorroded.
The batteries must sit flat in the battery wells.
The battery terminals should face towards the outside of the scooter.
WIRING HARNESSES
Regularly check all wiring connections.
Regularly check all wiring insulation, including the charger power cord, for wear or damage.
Have your authorized Provider repair or replace any damaged connector, connection, or insulation that
you find before using your scooter again.
PROHIBITED! Even though the scooter has passed the necessary testing requirements
for ingress of liquids, you should keep electrical connections away from sources of
dampness, including direct exposure to water or bodily fluids and incontinence. Check
electrical components frequently for signs of corrosion and replace as necessary.
WARNING! Do not pull on electrical harnesses directly to detach them from the scooter.
Always grasp the connector itself when disconnecting the harness to prevent wire
damage.
VIII. CARE AND MAINTENANCE
… 38 …


Need help? Post your question in this forum.

Forumrules
1

Forum

pride-colt-deluxe-2.0

Reset search

  • I bought a 'new' Pride Colt Deluxe 2.0. Later I discovered that both Track Rods where they fit on the Track Rod Ends as best as I could see has some play in them. I rang up the Shop who supplied it, & they sent someone out with a Tie Rap, & then put one on each of them to hold them firmly together. My question is, is this standard procedure when dealing with Mobility Scooters, or are they manufactured 'disabled' to be like the Owner ? Submitted on 3-10-2024 at 20:35

    Reply Report abuse

  • Console shows three green lights are out while charger is flashing fully charged Submitted on 15-10-2023 at 15:01

    Reply Report abuse

  • How do I enable the scooter to go from pushing to driving mode? Submitted on 1-7-2023 at 19:42

    Reply Report abuse

  • Why is my suspension on my pride deluxe Colt so tight Submitted on 21-9-2021 at 11:28

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Pride Colt Deluxe 2.0 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Pride Colt Deluxe 2.0 in the language / languages: English as an attachment in your email.

The manual is 2,42 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info