POWDP75100 EN
Copyright © 2021 VARO P a g e | 6 www.varo.com
▪ Do not use cutting blade which is bent, deformed or otherwise damaged.
▪ Do not use cutting blades which do not comply with the specifications stated in this
manual.
▪ Never start cutting tiles before the machine reaches full speed.
▪ Never attempt to cut extremely small workpieces.
▪ Do not leave the work area until the machine has been switched off and the cutting disc
has come to a complete standstill.
▪ Never attempt to stop the cutting blade by exerting pressure on the side of the blade.
▪ Always unplug the battery before performing any maintenance.
▪ Do not use the machine before it has been completely assembled and installed
according the instructions.
▪ Do not perform any design, assembly or construction activities on the table while the
machine is switched on.
▪ Unplug the battery and clean the table before leaving the work area.
▪ Take care that the selection of the diamond discs is suitable for the material to be cut.
▪ Faults in the machine, including guards or diamond discs, should be reported as soon as
they are discovered. Never use the machine without the guard in position.
▪ Maximum size of working piece should be 1m².
▪ This tile cutter should be used with limitations on ambient conditions (between 15 °C and
30 °C).
▪ Sharp edges and splinters of ceramic tiles can easily cause cuts. Wear work gloves for
handling and while cutting tiles.
▪ Keep hands away from cutting area and blade.
▪ Keep your body positioned to either side of the blade, but not in line with the blade.
Kickback could cause the tool to jump backwards.
▪ Do not reach underneath the workpiece. The guard cannot protect you from the blade
below the workpiece.
▪ Do not attempt to remove cut material when the blade is rotating. Note that the blade will
continue to coast for a while after the motor is switched off.
▪ Never wet cut with blades designed for dry cutting. There is danger of blade fracture and
serious personal injury.
▪ Diamond blades do not cut material, rather they grind material to perform a cutting action.
Do not feed the blade into the tile/masonry faster than the blade can grind.
▪ Never grind a tile using the side of the blade, or try to make radius or curve cuts. This will
damage the blade and could cause blade fracture.
7 ADDITIONAL SAFETY INSTRUCTIONS FOR BATTERIES AND
CHARGERS
Use only batteries and chargers applicable for this machine.
7.1 Batteries
▪ Never attempt to open for any reason.
▪ Do not store in locations where the temperature may exceed 40 °C.
▪ Charge only at ambient temperatures between 4 °C and 40 °C.
▪ Store your batteries in a cool dry place (5 °C-20 °C). Never store batteries in discharged
state.
▪ It is better for Li-ion batteries to discharge and reload them regularly (at least 4 times a
year). The ideal charge for long-term storage of your Li-ion battery is 40% of capacity.
