643482
32
Zoom out
Zoom in
Previous page
1/52
Next page
DT2011659-00
6.13 START UP ANd NORMAL OPERATION
•Before proceeding with lighting the stove:
a Ensure that the hearth door is well closed.
a Never use gasoline, gasoline-type lantern fuel, kerosene,
charcoal lighter uid, or similar liquids to start or ”freschen
up” a re in this heater. Keep all such liquids well away from
the heater wihle it is in use.
a Warning against overring:
- Pellets must not be fed manually into the burn pot.
- Never add additional fuel by hand.
- Do not ll the hopper with any fuels other than wood pellet.
- Accumulated un-burnt pellets in the burn pot after a failed
ignition must be removed before starting a new ignition
process.
Description of activity Display
Keep key 4 pressed down for a few seconds.
A cycle starts with three phases which take the stove into the normal operating mode.
- CONTROL (rst 20 seconds).
The lighter (glow plug) activates.
12:30 CONTROL
START PHASE I
The extractor fan starts up.
The fuel-loading auger is activated and starts to feed pellets into the grate.
12:30 START
PHASE I
START PHASE II
- If the lighter has triggered the combustion process, the auger increases fuel loading
to allow a period of stabilisation and correct combustion of the pellets in the
subsequent normal operating mode.
- If during the startup phase the sensor on the ue gas outlet shows a rise in
temperature (sign that the combustion process is underway), the stove is considered
to be lit and goes into the normal operating mode.
12:40 START
PHASE II
Description of activity Display
If the readout NO LIGHTING appears on the display during the startup stage (and the
buzzer activates, if set), it means that the sensor installed on the ue gas outlet detects
no temperature rise (sign that the combustion process has not been triggered) or the
pellet hopper is empty. The stove goes into the alarm status.
12:30 NO LIGHTING
Shut down the stove by pressing key 4 for a few seconds: the warning buzzer stops.
The scrolling readout CLEANING GRATE appears on the display and when the stove has
cooled the readout OFF appears.
Check the causes of activation of the safety device and always remove all the fuel from
the grate before attempting ignition again.
12:30 CLEANING
GRATE
Restart the stove by pressing key 4.
Repeat the procedure given above for lighting the stove.
12:50 CONTROL
a If the stove occasionally fails to ignite it could be caused by:
- pellet composition or size not in compliance with the specications given in this booklet (see the “FUEL” section);
- insufcient mains voltage, whether in the form of intermittent voltage drops or a constantly lower value.
In the above cases any call-out of the service centre is not covered by the warranty, since the problem is not due to a defect in
the product.
STOVE STARTUP
DT2011660-00
IGNITION FAILURE
DT2011661-00
a Operate unit only with hopper lid closed.
Failure to do so may result in emmision of products of
combustion from the hopper under certain conditions.
a The mains plug is properly inserted into the socket.
•Check that the pellet tank is full or at least contains enough pellets for
the stove to run for the desired period.
H07029330 / DT2001081 – 02
32
English
32


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Piazzetta SABRINA at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Piazzetta SABRINA in the language / languages: English as an attachment in your email.

The manual is 2,92 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info