763020
20
Zoom out
Zoom in
Previous page
1/49
Next page
20 GB/IE/NI
Troubleshooting
Air current cannot
be regulated? Compressed air hose
damaged or faulty.
Valve/manometer fails.
New connection of the hose.
HF-arc is not
created? The burner switch is faulty.
Soldering point on the burner
switch or plug loosened.
Valve/manometer fails.
Renew electrode.
Bad ignition? Burner wear parts damaged
or worn.
Check HF spark gap.
Change wear parts.
Set spark gap.
Plasma burner 8
is not ready for
operation?
Current switch is switched off.
Air transmission is restricted.
Workpiece is not connected to
the ground terminal.
Switch the current switch
to “on”.
Another indication of this is
a green flame. Check the air
supply.
Check the connections.
Sparks fly
upwards, instead
of down through
the material?
Burner sleeve 8c does not
penetrate the material.
Burner sleeve 8c is too far
away from the material.
Apparently material was not
grounded properly.
Lifting speed is too quick.
Increase the current.
Reduce the distance between
the burner sleeve 8c and
material.
Check the connection for
correct grounding.
Reduce the speed.
Initial cut but not
completely drilled
through?
Potential connection problem. Check all connections.
Slag formation on
interfaces? Tool/material creates heat.
Cutting speed too low or
current too high.
Plasma burner component
parts are worn 8b, 8c , 8d, 8e.
Allow the material to cool
down and then continue
cutting.
Increase the speed and/or
reduce the current until the
slag has been reduced to a
minimum.
Check and replace worn
parts.
327358_Plasmaschneider_PPS_40_B2_content_LB6_IE_NI.indb 20 06.09.2019 12:41:03
20


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Parkside PPS 40 B2 - IAN 327358 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Parkside PPS 40 B2 - IAN 327358 in the language / languages: English, German as an attachment in your email.

The manual is 2,1 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info