688917

Olimpia Splendid Unico Boiler Manual

44
Zoom out
Zoom in
Previous page
1/124
Next page
44
ENGLISH
2
2.2.2 Choice of position for UNICO BOILER WALL unit
The position for installation of the unit, to obtain the best performance and prevent breakdowns or hazards, must have the following
requisites:
- The wall on which the boiler is installed must be sturdy and able to withstand its weight.
- It must be possible to leave room around the unit for any maintenance operations that may be necessary.
- The following connections must be available near to the appliance: the pipes of the cold water supply and domestic hot water
supply and the electrical power supply (230V 1ph 50Hz).
2.2.3 Drilling the wall (gs. 5, 26)
Once the conditions described in chap. 2.2.2 have been satised, the wall must be drilled to t the wall plugs that x the boiler,
taking into account the distances shown in gure 5.
- The boiler must be xed to the wall in the chosen position using four wall plugs with bolts.
- Make the holes for the wall plugs referring to the dimensions specied in g. 31.
- In any case a careful examination of the characteristics and consistency of the wall is necessary in order to choose the correct
wall plugs for specic situations.
WARNING: : the manufacturer cannot be held responsible for any underestimation of the structural consistency of the xings
made by the installer.
You are therefore advised to take the utmost care over this operation, which, if performed incorrectly, could cause serious
injury to persons or damage to property.
- To make installation easier use two wall plugs with hooks to x the top bracket. To anchor the boiler safely, the bottom bracket
must be xed using two wall plugs with threaded pins, washers and lock nuts; the wall plug pins must pass through the relative
holes in the bracket.
2.2.4 Drilling pipe passage holes
If the connecting pipelines arrive from the rear wall of the boiler, it will be necessary to drill a hole in the wall for passage of the
pipes.
- Drill the hole at the centre of the site of installation using an 8-10 mm bit and tilting it downward towards the outside by 5%.
Finish the hole with a 60 mm auger.
- Fit the coolant lines and the communication cable with the UNICO BOILER MASTER unit through the hole.
2.2.5 Installation of unit
- Hang the boiler onto the hooks on the wall as described in paragraph 2.2.3 on the top wall plugs and x the bottom bracket
with a nut and washer.
- Make sure the cable is disconnected from the power mains.
Make the pipe connections as described in par. 2.2.7.
… 44 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Olimpia Splendid Unico Boiler at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Olimpia Splendid Unico Boiler in the language / languages: English, German, French, Italian, Spanish as an attachment in your email.

The manual is 21,81 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info