•Heavy-duty scourers, some nylon scourers and harsh/abrasive cleaning agents may scratch the glass. Always read the label to check if your cleaner or
scourer is suitable.
•Heavy-duty scourers, some nylon scourers and harsh/abrasive cleaning agents may scratch the glass. Always read the label to check if your cleaner or
scourer is suitable.
•Never leave cleaning residue on the cooktop: the glass may become stained.
•Clean the hob after each use. This will prevent spills from burning onto the ceramic.
•Use only cleaning agents which are suitable for glass ceramic. Follow the cleaning instructions on the packaging.
Never use:
•Undiluted washing-up liquid
•Detergent intended for dishwashers
•Scouring agents
•Harsh cleaning agents such as oven spray or stain remover
•Abrasive sponges
•High-pressure cleaners or steam jet cleaners.
•The surface of the induction hob may be easily cleaned in the following way:
Type of dirtCleaning method
Everyday soiling on glass (nger-
prints, marks, stains left by food or
non-sugary spillovers on the glass).
1. Switch the power to the cooktop o.
2. Apply a cooktop cleaner while the glass is still warm but not hot.
3. Rinse and wipe dry with a clean cloth or paper towel.
Boil overs, melts, and hot sugary
spills on the glass.
Important:
Remove stains left by melts and sugary food or spillovers as soon as possible. If left to cool on the glass, they
may be dicult to remove or even permanently damage the glass surface.
Remove these immediately with a sh slice, palette knife or razor blade scraper suitable for ceramic glass
cooktops. Beware of hot cooking zone surfaces!
1. Switch the power to the cooktop o at the wall.
2. Hold the blade or utensil at a 30° angle and scrape the soiling or spill to a cool area of the cooktop.
3. Clean the soiling or spill up with a dish cloth or paper towel.
•Warning!Cut hazard! When the safety cover is retracted, the blade of a scraper is razor-sharp. Use with
extreme care and always store safely and out of reach of children.
Spillovers on the touch controls.1. Switch the power to the cooktop o.
2. Soak up the spill.
3. Wipe the touch control area with a clean damp sponge or cloth.
4. Wipe the area completely dry with a paper towel.
Note: The cooktop may beep and turn itself o, and the touch controls may not function while there is liquid
on them. Make sure you wipe the touch control area dry before turning the cooktop back on.
INSTALLATION
Required accessories (not supplied)
•Phillips screwdriver
•Screwdriver
•Silicone
•Pencil and ruler/measuring tape
Preparation - Before you install the appliance, make sure that...
•The work surface is square and level, and no structural members interfere with space requirements.
•The work surface is made of a heat-resistant material.
•If the appliance is installed above an oven, the oven has a built-in cooling fan.
•The installation will comply with all clearance requirements and applicable standards and regulations.
•A suitable isolating switch providing full disconnection from the mains power supply is incorporated in the permanent wiring, mounted and
positioned to comply with the local wiring rules and regulations. The isolating switch must be easily accessible to the customer with the hob
installed.
•If the appliance is installed above a drawer or cupboard space, a thermal protection barrier is installed below the base of the hob.
•The isolating switch must be of an approved type and provide a 3 mm air gap contact separation in all poles (or in all active [phase] conductors if the
local wiring rules allow for this variation of the requirements).
•If the appliance is being connected directly to the mains, an omnipolar circuit-breaker must be installed with a minimum opening of 3 mm between
contacts.
•You consult local building authorities and by-laws if in doubt regarding installation.
•You use heat-resistant and easy-to-clean nishes (such as ceramic tiles) for the wall surfaces surrounding the appliance.
Installation requirements
Caution!
•This appliance must be earthed.
•The induction hob must be installed by a suitably qualied person. Never try to install the appliance yourself.
•The induction hob must not be installed above refrigerators, freezers, dishwashers or tumble dryers.
•The wall and the area above the hob should be able to withstand heat.
•The worktop should be at least 30 mm thick and made of a heat-resistant material.
•Do not install the appliance directly above a dishwasher, fridge, freezer, washing machine or clothes dryer, as the humidity may
damage the hob electronics.
•The power supply cable must not touch any hot parts and must be positioned so that its temperature will not exceed 75 ˚C at any
Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.
Product:
Forumrules
To achieve meaningful questions, we apply the following rules:
First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.
Register
Register getting emails for OK OBH39831 at:
new questions and answers
new manuals
You will receive an email to register for one or both of the options.
Get your user manual by e-mail
Enter your email address to receive the manual of OK OBH39831 in the language / languages: English, German, Dutch, French, Italian, Polish, Portuguese, Swedish, Turkish, Spanish as an attachment in your email.
The manual is 10,47 mb in size.
You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.
The manual is sent by email. Check your email
If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.
The email address you have provided is not correct.
Please check the email address and correct it.
Your question is posted on this page
Would you like to receive an email when new answers and questions are posted? Please enter your email address.
