663191
7
Zoom out
Zoom in
Previous page
1/15
Next page
EN
EN
Install the shift cable hardware
following steps A, B and C.
Check the spring latch to
ensure it is seated properly.
3. REAR WHEEL INSTALLATION/REMOVAL
Fitting the Rear Wheel
Place the rear wheel into the
rear frame, making sure not to
obstruct shift cables.
Slide one no-turn washer
(1)
each onto each axle end. The
serrations of the no-turn washer
must bear against the dropout of
the frame. The rectangular boss
must engage in the dropout of the
frame.
Mount the axle nuts (2).
Tightening torque 30 – 40 Nm
(266-350 in-lbs).
For roller brake applications,
connect the roller brake
according to the manufacturer’s
instructions.
1
2
Boss
1
A
B
C
Do not push on the spring
portion of the OD latch (3)
when closing.
3
Improper installation of the
no-turn washer will result in
damage to the dropout and
the hub.
Over-tightening may damage
parts. Under-tightening can
result in the axle sliding in the
dropouts.
3. REAR WHEEL INSTALLATION/REMOVAL
Disconnecting the Rear
Wheel
Shift to a position that allows
easy access to the shift cable
hardware.
Remove shift cable hardware
following steps A, B and C.
Loosen and/or remove the
axle nuts (3) and the no-turn
washers (4).
For roller brake applications,
disconnect the roller brake
according to the manufacturer’s
instructions.
Remove the rear wheel.
A
B
C
3
4
3
4
11
12
3.1
3.2
3.3
3.4
3.1
3.2
3.3
3.4
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for NuVinci N360 -2010 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of NuVinci N360 -2010 in the language / languages: English as an attachment in your email.

The manual is 7,3 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of NuVinci N360 -2010

NuVinci N360 -2010 User Manual - German - 15 pages

NuVinci N360 -2010 User Manual - Dutch - 15 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info