629278
11
Zoom out
Zoom in
Previous page
1/40
Next page
NX-10 User Manual 11
Arming and disarming using a single-partition keypad
2. The keypad starts to blip and the system begins to arm.
3. Leave the building. The keypad blips increase during the last 10
seconds of the exit time.
4. When the exit time expires, your system is armed and the keypad
sounds continuously for 2 seconds. The status indicator lights red.
Disarming your system
1. When you open the door to enter the secured partition, the entry delay
starts and the keypad sounds continuously.
2. Enter your user code. When entering code, the number of code digits
entered is displayed in the right lower corner (1, 2, 3, etc.).
Your system is disarmed and the keypad sounder stops. The status indicator
changes to green.
Note: Press NO key to clear any incorrectly entered user code or other
information.
1. Unblank the keypad, if necessary, by pressing the NO key, and then
enter your user code at the system prompt. You can also press the
function key to do it immediately.
A keypad can be programmed as a single-partition keypad or a master keypad. A single-partition keypad allows you to arm one partition
only while a master keypad allows you to arm one or more partitions. Both keypad modes allow you to bypass zones within the partition(s)
you are arming. For more information on bypassing zones, see page 17.
........
........
........
........
........
........
........
........
System Ready
Type Code to Arm
System Arming
Leave Now
System Armed
All Zones Secure
System Ready
Type Code to Arm
Type code to
Disarm
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for NetworX NX-10 - V3 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of NetworX NX-10 - V3 in the language / languages: English as an attachment in your email.

The manual is 0,75 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of NetworX NX-10 - V3

NetworX NX-10 - V3 Quick start guide - Dutch - 2 pages

NetworX NX-10 - V3 User Manual - Dutch - 40 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info