629278
40
Zoom out
Zoom in
Previous page
1/40
Next page
NX-10 User Manual 40
Arming
1. Arming in the EN50131 mode differs slightly from arming the
standard system (see page 11) because in this mode the screen
saver is always active. Therefore you have to enter your user code
first to cancel the screen saver, and then to enter your user code
again to arm the system (if arming is allowed). If the system is not
ready, the appropriate message is displayed (see Fault
acknowledging/overriding). When entering code, the number of
code digits entered is displayed in the right lower corner (1, 2, 3,
etc.).
2. The keypad starts to blip and the system begins to arm.
3. Leave the building. The keypad blips increase during the last 10
seconds of the exit time.
4. When the exit time expires, your system is armed and the keypad
sounds continuously for 2 seconds. The status indicator lights red.
Disarming
Disarming process in the EN50131 mode is identical as in the
standard system (see page 11).
Incomplete Exit
If during arming, the Entry/Exit zone (for example, an exit door) is
open at the end of the exit time then the system will not be armed
and the special Exit Error code will be reported. Each Exit Error event
is visible as a fault and it should be acknowledged.
Power supply problems
In case of power supply problems, the following icons are displayed:
Power
Normal
mode
Screensaver
mode
No faults ON ON
AC fault
Battery OK
ON ON Blinking
AC OK
Battery fault
Blinking ON Blinking
AC fault
Battery low
ON ON Blinking
AC OK
Battery low
Blinking ON Blinking
EN50131 Mode
40


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for NetworX NX-10 - V3 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of NetworX NX-10 - V3 in the language / languages: English as an attachment in your email.

The manual is 0,75 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of NetworX NX-10 - V3

NetworX NX-10 - V3 Quick start guide - Dutch - 2 pages

NetworX NX-10 - V3 User Manual - Dutch - 40 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info