667811

NAD M32 DirectDigital DAC Amplifier Manual

8
Zoom out
Zoom in
Previous page
1/24
Next page
7 POWER
• The POWER switch supplies the master AC mains power for the
M32.
• When the POWER switch is set to ON position, the M32 goes to standby
mode as shown by the amber status condition of the front panel Power
indicator. Press the front panel Standby button or HTRM 2’s remote
control’s [ON] button to switch ON the M32 from standby mode.
• If you do not intend to use the M32 for long periods of time (such
as when on vacation), switch o the POWER switch.
• With POWER switched o, neither the front panel Standby button
nor HTRM 2 remote control’s [ON] button can activate the M32.
8 DIGITAL AES/EBU
• Connect SACD/CD Players or processors to this XLR connector for
digital audio streaming.
• High-end sources with higher sampling rates (176kHz and 192kHz)
should be connected to the AES/EBU IN connector.
9 COMPUTER
• Use a Type A to Type B cable connector (not supplied), to interface
computer audio to this asynchronous Type B USB input to directly
stream 24/96 PCM content from your PC or MAC.
• The Type A-style connector is a at, rectangular interface.
• The Type B-style interface is square in shape and has beveled
corners on the top ends of the connector.
• Refer to LISTENING TO COMPUTER in the OTHER FEATURES section
on the OPERATION page.
10 SERVICE
Use for servicing purposes only. Not for consumer use.
11 INPUT
PHONO: Input for a Moving Magnet (MM) phono cartridge. Connect
the twin RCA lead from your turntable to this input if you are using a
Moving Magnet cartridge.
LINE1, LINE 2: Input for line level sources such as CD player, tuner or
any compatible devices. Use a twin RCA-to-RCA lead to connect the
source device’s left and right “Audio Output” to this input.
12 OUTPUT (PRE-OUT/SUBW)
• These output terminals have dual function. They are used either as
PRE-OUT or SUBWOOFER terminals.
• The M32 and associated external devices must be turned OFF always
before connecting or disconnecting anything to the OUTPUT sockets.
IMPORTANT
Set the “Sub Output” option under “Speaker Setup” settings to “ON” for
the OUTPUT terminals to function as Subwoofer out. On the other hand,
the OUTPUT terminals will function as PRE-OUT if the “Sub Output”
option is set to “OFF”.
PRE-OUT
• The PRE OUT/SUBW sockets make it possible for the M32 to be used
as a full range preamplier to an external power amplier.
• Use a dual RCA cable to connect PRE-OUT/SUBW to the
corresponding analog audio input of compatible devices such as
ampliers, receivers or other applicable devices.
• PRE-OUT/SUBW will be aected by the M32’s volume control
settings. Turn the VOLUME control to adjust the output level of the
PRE OUT/SUBW sockets.
SUBWOOFER
• Use a dual RCA cable to connect PRE OUT/SUBW to the low level
input of a powered subwoofer.
• Low frequency information up to 200Hz is sent to the connected
subwoofer via PRE OUT/SUBW.
13 AC MAINS INPUT
• The M32 comes supplied with two separate mains power cords.
Select the mains power cord appropriate for your region.
• Before connecting the plug to the mains power source, ensure that
it is rmly connected to the M32’s AC Mains input socket.
• Always disconnect the mains power plug from the mains power
source before disconnecting the cable from the M32’s AC Mains
input socket.
14 FUSE HOLDER
• Only qualied NAD service technicians can have access to this fuse
holder. Opening this fuse holder may cause damage thus voiding
the warranty of your M32.
15 GROUND TERMINAL
• Ensure that the M32 is plugged-in to a grounded AC wall outlet.
• If necessary, use this ground terminal to connect to ground a
phono or turntable source for PHONO input.
• If a separate earth ground is necessary, use this terminal to ground
your M32. The M32 can be connected to ground by connecting a
ground lead wire or similar to this terminal. After insertion, tighten
the terminal to secure the lead.
NOTES
• The above illustration shows the M32 being connected to ground via
a metal water pipe. There maybe other grounding conductor points
in your home. Consult with a licensed electrician to locate or install
a grounding conductor in your home. NAD is not responsible for
any malfunction, damage or costs associated with the installation,
connection, or grounding of your M32.
• The grounding wire is not supplied with your M32.
IDENTIFICATION OF CONTROLS
REAR PANEL
8
ENGLISH FRANÇAIS ESPAÑOL ITALIANO DEUTSCH NEDERLANDS SVENSKA РУССКИЙ
… 8 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for NAD M32 DirectDigital DAC Amplifier at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of NAD M32 DirectDigital DAC Amplifier in the language / languages: English as an attachment in your email.

The manual is 3,6 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of NAD M32 DirectDigital DAC Amplifier

NAD M32 DirectDigital DAC Amplifier User Manual - German - 24 pages

NAD M32 DirectDigital DAC Amplifier User Manual - Dutch - 24 pages

NAD M32 DirectDigital DAC Amplifier User Manual - French - 24 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info