451459

Metabo KS 254 Plus Manual

23
Zoom out
Zoom in
Previous page
1/56
Next page
2.8
KS 250
Compound mitre cuts
3
A compound mitre cut is the combination of
mitre and bevel cut. Here the workpiece is cut
at an angle other the 90° across its width and
at the same time cut at an angle other than
90° vertical through its surface.
Starting position:
- Sawhead fully lifted
(if necessary, pull out locking pin);
- Set turntable to desired position.
- Tilt sawhead to desired bevel angle.
Execution:
The cutting operation is the same as described in
„standard cross cuts“.
Care and maintenance
A
Danger!
Prior to all servicing:
- Switch machine OFF.
- Unplug power cable.
- Wait until the saw has come to a complete
stop.
· Check that all safety devices are operational
again after each service.
· Replace defective parts, especially of safety
devices, only with genuine replacement parts.
Parts not tested and approved by the equipment
maker can cause unforeseen damage.
· Repair and maintenance work other than
described in this section should only be carried
out by qualified specialists.
Saw blade change
A
Danger!
Directly after cutting the saw blade may be
very hot – risk of burns! Let a hot saw blade
cool down. Do not clean the saw blade with
combustible liquids.
Risk of injury, even with the blade at stand-
still. Wear gloves when changing blades.
On re-assembly observe direction of rotation
of inner blade collar, saw blade and outer
blade collar!
1. Unscrew the three screws (A), (B) and (C) on
the saw blade guard and remove the saw blade
guard.
2. To lock the saw blade in position, depress the
lock knob and turn the saw blade with your other
hand until the lock engages.
3. Loosen arbor bolt with box wrench (left-hand
thread!).
4. Remove from the saw blade shaft:
- arbor bolt,
- washer,
- outer blade collar,
- saw blade and
- inner blade collar
5. Clean clamping surfaces of:
- saw spindle,
- saw blade,
- outer blade collar,
- inner blade collar.
B
C
A
… 23 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Metabo KS 254 Plus at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Metabo KS 254 Plus in the language / languages: English, German, Dutch, French, Italian as an attachment in your email.

The manual is 2,28 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info