789308
60
Zoom out
Zoom in
Previous page
1/161
Next page
60
Setting the saw depth
The saw arm must be locked and in the top
position.
Adjust the depth adjustment screw (26)
towards the stop plate (25). Make sure that
the saw depth is not set so that the saw
blade comes into contact with the base of
the saw.
Sawing
Check that the mitre saw is correctly set up
and that all knobs and screws are correctly
tightened before starting to saw.
Lift the clamp (23) high enough so that the
workpiece can be pushed between it and the
saw bench. Position the workpiece touching
the saw bench and rest (5/6) so that it is
stable. Then secure the workpiece using the
knob on the clamp.
If necessary, open the length stop (14) on
one of the pull-out rails (7) if you intend to
saw several workpieces to the same length.
Make sure that long workpieces are
supported. Never hold the item in place by
hand.
Release the lock switch (1) and press the ON/
OFF button (2) to start the motor..
Allow the mitre saw to achieve full speed
before applying it to the workpiece.
The blade guard will open automatically
when the blade comes into contact with the
item.
Do not try to force the saw to either side.
Release the on/o button immediately if the
blade jams in the workpiece.
Release the on/o button once sawing is
complete. Only lift the saw arm once the
blade has fully stopped.
Check that the blade guard closes when the
saw is lifted o the item.
Sawing with the telescopic extension
Loosen the lock knob for the telescopic
extension (33).
Pull the saw arm out towards you as far as
possible. Start the saw as described, and cut
the workpiece from the outside in. Release
the on/o button once sawing is complete.
Only lift the saw arm once the blade has fully
stopped.
Replacing the saw blade
Disconnect the saw from the mains.
Remove the screw that holding the bracket
in the place on movable blade guard (4).
Press the release button (2) for the blade
guard and push the blade guard (4) fully up.
60


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Max 32891 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Max 32891 in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Swedish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 3.31 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info