598435
17
Zoom out
Zoom in
Previous page
1/24
Next page
17
Cleaning the air lter - Loosen the screws (A/1) and remove the air lter cover
(A/2).
- Take the foam lter out of the cover.
Caution: To prevent eye injuries, do not blow out dirt
particles!
- Very dirty lters can be cleaned out using regular dishwash-
ing liquid in lukewarm water.
- If it is very dirty clean it more often. Only a clean lter ensures
full engine power!
- Before reinstalling the air lter check the choke valve for dirt
particles, and if necessary clean it out with a brush.
- Carefully dry the air lter and reinstall it.
- First insert the air lter cover (A/2) in the groove (A/4) and
then af x with the screw (A/1).
Important: If the air lter is damaged replace it immediately!
Torn-off fabric pieces and large dirt particles can destroy
the engine!
Inspecting the
spark plug
CAUTION!
NEVER touch the spark plug or spark plug cap while the
engine is running (high voltage)!
Never do maintenance work with the engine running!
A hot engine can cause severe burns. Wear protective
gloves!
The spark plug must be replaced if the insulator is damaged or
if the electrodes are severely eroded or dirty or oily.
- Pull the spark plug cap (B/6) off the plug. Remove the spark
plug with a spark plug wrench (19 mm size).
Note:
Replace only with NGK BPMR8Y spark plugs!
Electrode gap
The electrode gap must be 0.6 - 0.7 mm.
Replacing the
spark plug
- Insert the wrench (C/7) between the housing and the cylinder,
only as shown in the illustration.
CAUTION!
Do not insert the wrench into the spark plug hole. Make
contact only with the cylinder (otherwise you may damage
the engine).
- Firmly connect the spark plug cap to the spark plug (removed
from the engine) and hold it against the wrench using insu-
lated pliers (away from the spark plug hole!).
- Move the combination switch (I/O) to the “I” position.
- Pull the starter cable hard.
A spark should be visible at the electrode gap.
A
B
C
17


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Makita BCM3310 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Makita BCM3310 in the language / languages: English as an attachment in your email.

The manual is 1,55 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info