Manual MakerBot Replicator 2 - MB1036 (page 21 of 45) (German)

534674

Zoom out

Zoom in

1/45

21!

7 Führen Sie das Filament-Gleitrohr zurück

Schieben Sie das Gleitrohr wieder in die Extruderöffnung oben.

HINWEIS: Wenn Sie Probleme dabei haben oder das MakerBot PLA-Filament wieder

laden müssen, können Sie mithilfe der Aufwärts-und Abwärts-Pfeile durch das Top-

Level-Menü auf dem LCD-Display blättern und mit der M-Taste das Menü

"Dienstprogramme" wählen. Scrollen Sie zum Menüpunkt "Filament auswechseln"

und wählen Sie ihn. Dann wählen Sie Load. Sie können mit diesen Menüs jederzeit zum

Lade-Script zurückkehren.

8 Entfernen Sie den extrudierten Kunststoff

Warten Sie ein paar Minuten bis der extrudierte Kunststoff abkühlt, dann

streifen Sie ihn von der Düse. Sie können dieses überflüssige Filament

wegwerfen. Berühren Sie nicht die Düse, sie könnte noch heiß sein.

Lassen Sie keinen Kunststoff an der Extruderdüse kleben. Dies kann

dazu führen, dass neu extrudierter Kunststoff auf der Düse statt auf der

Bauplattform kleben bleibt.

Entladen des MakerBot PLA-Filaments

Um das MakerBot PLA-Filament zu entladen, wählen Sie den

Menüpunkt "Vorheizen > Vorheizen starten" auf der LCD-Anzeige.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of MakerBot Replicator 2 - MB1036 in the language / languages: German as an attachment in your email.

The manual is 0,84 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of MakerBot Replicator 2 - MB1036

MakerBot Replicator 2 - MB1036 User Manual - English - 60 pages

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

MakerBot Replicator 2 - MB1036 Manual

Product: