534674

MakerBot Replicator 2 - MB1036 Manual

20
Zoom out
Zoom in
Previous page
1/45
Next page
!
20!
5 Schieben Sie das Filament in den Extruder
Drücken Sie den Extruder-Arm hinunter.
Halten Sie ihn fest nach unten, während Sie das lose Ende des Filaments
in die Extruderöffnung oben einfügen. Schieben Sie das Filament so weit
wie möglich hinein. Sie werden sehen, wie Kunststoff aus der
Extruderdüse auszutreten beginnt.
Lassen Sie den Extruder-Arm los.
6 Beenden des Extrudierens
Der Extruder-Motor wird auf das Filament zugreifen und es weiter
einziehen. Beobachten Sie den Vorgang um sicherzustellen, dass noch
Kunststoff aus der Düse austritt, nachdem Sie den Extruder-Arm
loslassen. Dann drücken Sie die M-Taste, um die Extrusion zu stoppen.
HINWEIS: Seien Sie nicht überrascht wenn das Filament, das anfänglich aus der Düse
kommt, nicht die Farbe hat die Sie erwarten. Es ist wahrscheinlich noch etwas Filament
innerhalb des Extruders von unserem Testprozess in der MakerBot-Fabrik übrig.
Warten Sie bis Sie die Farbe, die Sie eingelegt haben aus der Düse kommen sehen,
bevor Sie die M-Taste drücken.
… 20 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for MakerBot Replicator 2 - MB1036 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of MakerBot Replicator 2 - MB1036 in the language / languages: German as an attachment in your email.

The manual is 0,84 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of MakerBot Replicator 2 - MB1036

MakerBot Replicator 2 - MB1036 User Manual - English - 60 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info