534693
65
Zoom out
Zoom in
Previous page
1/104
Next page
Manual Leapfrog Creatr
65 Leapfrog BV
Once you have selected the correct filament type, adjust the temperatures by increasing the
temperature given for the first layer and the other layers set for the extruder. In the screenshot
shown you can see that these are set to 220 degrees Celsius. When you have adjusted the
Save-icon underneath the Filament Settings header to save the
changes in the settings.
Try to increase the temperatures in steps of 5-10 degrees with a limit of 245 and see if this
improves the printing result.
Print without using the filament guiding tubes
The filament guiding tubes through which the filament is fed into the extruder can cause drag
that makes it hard for the driver gear to pull the filament through. Printing without the use of the
tubes will reduce this drag. So remove the filament spool holders from the bottom of your Creatr
and place this holder on the top plate of your Creatr. Feed the filament directly from the spool
into the extruder and try to see if this improves the print result
65


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Leapfrog Creatr at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Leapfrog Creatr in the language / languages: English as an attachment in your email.

The manual is 8,17 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info