534693
64
Zoom out
Zoom in
Previous page
1/104
Next page
Manual Leapfrog Creatr
64 Leapfrog BV
The next steps
If all the checks mentioned earlier turn out to be okay, we advise you to follow the next steps
Clean your nozzle with your filament
It is important that the nozzle has no leftover filament inside it that are stuck. Please heat the
nozzle to 220/230 degrees and retract the filament until it is completely out of the extruder. Cut
off the last part from the just retracted filament and make sure your cut is perpendicular.
Heat the nozzle to 240 degrees Celsius, feed and extrude the filament. Hereby, the filament
should push any clogging parts through the hot end. This is a great way to clean your nozzle
without the hassle of removing the nozzle and placing it in a bowl of dissolvent. We would
recommend doing this on a regular basis when you start your prints as it is a fast and a good
regular check.
Printing at higher temperatures
Printing with a nozzle that is too cold can cause clogging. This can occur mid-print, because the
nozzle temperature fluctuates with a few degrees. If this happens, please increase the
temperature of your nozzle.
You can increase the print temperature by going to Repetier-HosSlicer tab.
Configure to enter the Slic3r settings menu. In the menu go to the
Filament settings tab and select the filament type of which you wish to change the setting as
indicated in the screenshot below
64


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Leapfrog Creatr at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Leapfrog Creatr in the language / languages: English as an attachment in your email.

The manual is 8,17 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info