534693
66
Zoom out
Zoom in
Previous page
1/104
Next page
Manual Leapfrog Creatr
66 Leapfrog BV
Changing the distance between the bearing and the driver gear
If none of the above has proven to be a solution, you can check if the distance between the driver
gear and the bearing of the extruder is set correctly.
In order to determine this, you will have to extrude some filament and then retract the filament.
If the bearing is too far away from the driver gear you will hardly see any marks on your retracted
filament. If this is the case, you will need to change the distance between the driver gear and the
bearing.
If the gear is a little bit too close to the driver, your filament will be deformed too much (see the
figure below). This causes the filament to be unable to pass through the hot end properly and it
will jam. The following description explains how to change the distance between the driver gear
and the bearing.
Figure: Sketch of the filament for three types of distances between the driver gear and the bearing. Left shows when they are too far apart. The
middle shows the correct distance and the right sketch displays the filament when the distance is too small.
66


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Leapfrog Creatr at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Leapfrog Creatr in the language / languages: English as an attachment in your email.

The manual is 8,17 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info