522406

KVH TracVision M9 Manual

22
Zoom out
Zoom in
Previous page
1/29
Next page
Appendix
23
Route and Secure the Cables
1. Remove the four M4 screws securing the
cable brackets to the inside rim of the
baseplate (see Figure 44). Remove and save
the cable brackets.
2. Route the data/power (F-type connector end)
(see Figure 45) and RF cables belowdecks
through the cable access hole. Leave an
adequate service loop, approximately 8"
(20 cm) of slack, in the cables for easy
serviceability. Later, you will connect the
data/power cable to the MCU and the RF
cable(s) to the receiver(s).
3. Route the N-type connector end of the data/
power cable (see Figure 45) through the
baseplate’s bottom cable access hole. Connect
the data/power cable to the center connector
on the cable PCB (see Figure 46).
4. Route the RF cable(s) through the baseplate’s
bottom cable access hole. Using a 9/16"
wrench, connect the RF cable(s) to the cable
PCB (see Figure 46). If you need to connect
only one RF cable, connect the cable to the
RF1 connector. Connect any additional RF
cables to the RF2, RF3, and RF4 connectors.
See Figure 9 on page 6 to determine the
number of RF cables required.
TIP: If you connect two or more RF cables, label both
ends of each cable to match the connector. This will
make it easier to identify the cables later.
Be sure to properly align the data/power
cable with the PCB connector before
tightening. Connecting the cable at an angle
may damage the cable’s center tines.
IMPORTANT!
Continued Bottom Cable Entry Kit
A
Figure 44 Cable Brackets on Inside Rim of Baseplate
Figure 45 Data/Power Cable Connections
Figure 46 Cable Connections on PCB
M4 Screw (x4)
F-type Connector N-type Connector
MCU Antenna
Data/
Power
RF1 RF3RF4 RF2
… 22 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for KVH TracVision M9 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of KVH TracVision M9 in the language / languages: English as an attachment in your email.

The manual is 7,39 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of KVH TracVision M9

KVH TracVision M9 User Manual - English - 73 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info