522406
21
Zoom out
Zoom in
Previous page
1/29
Next page
Appendix
22
Seal the Original Cable PCB Location
1. Peel off the paper backing from the large
cover plate gasket supplied in the kitpack.
Attach the gasket to the supplied cover plate,
making sure all holes are aligned. Also make
sure all of the holes will align with the holes
at the original PCB location, gasket side
facing down.
2. Position the large cover plate and gasket
(gasket side facing down) over the original
cable PCB location. Secure in place with the
five #4-40 screws and washers you removed
earlier. Apply a small amount of Loctite
threadlocker to the screw threads before
securing (see Figure 41).
Prepare the Bottom Cable Access Hole
1. Remove the two M4 screws from the small
cover plate and gasket inside the antenna
baseplate. Remove the small cover plate and
gasket (see Figure 42).
2. Peel off the paper backing from the rubber
seal and carefully attach the rubber seal to the
underside of the baseplate, ensuring a good
seal around the rim of the bottom cable access
hole (see Figure 43).
Continued Bottom Cable Entry Kit
Figure 41 Large Cover Plate and Gasket
Figure 42 Small Cover Plate and Gasket
Figure 43 Rubber Seal on Underside of Baseplate
#4-40 Screw (x5)
Large Cover
Plate and Gasket
Antenna
Assembly
M4 Screw (x2)
Small Cover
Plate and Gasket
Rubber Seal
Note: You will route
these cables later
in the procedure.
A
21


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for KVH TracVision M9 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of KVH TracVision M9 in the language / languages: English as an attachment in your email.

The manual is 7,39 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of KVH TracVision M9

KVH TracVision M9 User Manual - English - 73 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info