522406
20
Zoom out
Zoom in
Previous page
1/29
Next page
Appendix
21
If you wish to route the system cables through
the bottom of the antenna’s baseplate, rather than
connect the cables at the side of the baseplate,
follow these steps to modify the antenna for
bottom cable entry. Figure 38 shows the relevant
parts of the antenna baseplate; refer to this figure
throughout the procedure.
Remove the Radome and Restraints
1. Perform Steps 7a through 7d on page 9 to
remove the antenna’s radome and shipping
restraints. You will need to rotate the antenna
assembly by hand to access various parts of
the baseplate.
Relocate the Cable PCB
1. Remove the tie-wrap securing the cable PCB
(printed circuit board) wires to the baseplate
access hatch (see Figure 39).
2. Remove the five #4-40 screws, washers, and
nuts securing the cable PCB to the access
hatch (see Figure 39).
3. Attach the cable PCB to the alternate cable
PCB bracket (see Figure 40) using the five
#4-40 screws and washers supplied in the
kitpack. Apply a small amount of Loctite
threadlocker to the screw threads before
securing.
Once you have removed the restraints,
handle the antenna very carefully. With the
restraints removed, the internal antenna
assembly rotates freely and, if not handled
properly, can damage the limit switch.
IMPORTANT!
Bottom Cable Entry Kit
A
Figure 38 Interior Baseplate (Antenna Not Shown)
Figure 39 Cable PCB in Original Location
Figure 40 Cable PCB in Alternate Location
Baseplate
Hatch
Original Location
for Cable PCB
Small
Cover Plate
Alternate Location
for Cable PCB
Cable
Brackets
#4-40 Screws (x5)
Tie-wrap
Original Location
Alternate
Location
#4-40
Screw (x5)
20


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for KVH TracVision M9 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of KVH TracVision M9 in the language / languages: English as an attachment in your email.

The manual is 7,39 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of KVH TracVision M9

KVH TracVision M9 User Manual - English - 73 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info