683161
154
Zoom out
Zoom in
Previous page
1/196
Next page
This transceiver does not support IPv6.
This transceiver supports ping and other ICMP
responses.
The Ethernet standard used on this transceiver is
100BASE-TX. Use a commercially available cable that
is Category 5 (Cat5) or higher.
When connecting to a hub or broadband router, make
use of a commercially available straight cable.
Turn off the power of this transceiver and the device to
connect to before connecting the cable.
Even when the IP address is acquired automatically, IP
address cannot be configured in an environment where
a DHCP server is not used.
When the IP address is acquired automatically, the IP
address, subnet mask, default gateway, primary DNS
server and secondary DNS server are grayed out and a
parameter cannot be input.
When an IP address is automatically acquired and
configured for this transceiver, the configured IP address
is displayed in the IP address setting.
Setting DHCP to ON updates the parameter. If an
address is not acquired, the address field will remain
blank.
The address may not be acquired immediately after
DHCP is set to ON.
Even when the IP address is configured while DHCP is
OFF, this IP address will be displayed when DHCP is set
to ON.
Viewing the MAC Address
The MAC address of this transceiver which is necessary for its
operation via LAN can be identified in this menu item.
Check LAN Menu [6]
MAC Address.
The MAC address of this transceiver can be identified here.
This menu item is intended for viewing only, and the setting in
LAN Menu [6] MAC Address cannot be altered.
KNS Operation
KNS (KENWOOD NETWORK COMMAND SYSTEM) is a
collective term that refers to the system for remotely operating a
KENWOOD transceiver via the network such as the Internet or
LAN. Operation using this system is referred to as “KNS
operation”.
The ARCP-890 and other related programs for remote
operations, and “TS-890S KENWOOD NETWORK
COMMAND SYSTEM Setting Manual” can be
downloaded from the URL below.
http://www.kenwood.com/i/products/info/amateur/
software_download.html
This manual describes only the explanation on the areas
of the transceiver configuration. For details on specific
configurations, please refer to “TS-890S KENWOOD
NETWORK COMMAND SYSTEM Setting Manual”.
System Configuration Overview
Basic Configuration for Remote Operation through the Internet
To operate the TS-890S remotely through the Internet using KNS,
configure the system as shown in Figure 1.
.
TS-890S
Remote PC with
ARCP-890
LAN
Connection
Broadband
Router
Broadband
Router
Internet
Figure 1: Basic System Configuration
Under this configuration, the TS-890S performs login authentication
of the remote user (administrator and registered user) operating the
ARCP-890, followed by control command communication after
authentication is complete. Voice communication is carried out by
the TS-890S and ARCP-890 via the built-in VoIP.
Administrator refers to the owner of or person in charge
of managing the transceiver. Registered user refers to a
user other than the administrator who is authorized to
operate this transceiver remotely via KNS. A registered
user needs to be registered in advance by the
administrator to the KNS users list in the TS-890S.
Configuration when Using ARVP-10 or a Non-
KENWOOD VoIP for Voice Communication
When using ARVP-10 or a non-KENWOOD VoIP application
software program for voice communication, configure the system
as shown in Figure 2.
.
TS-890S
Voice
Host PC
VoIP Application
Remote PC with
ARCP-890
VoIP Application
LAN Connection
Hub
Broadband
Router
Broadband
Router
Internet
Figure 2: System Configuration when Using a Non-
KENWOOD VoIP Application
Under this configuration, voice communication between the
remote PC and host PC is carried out using the ARVP-10 or a non-
KENWOOD VoIP application software.
Voice communication between the host PC and the TS-890S is
carried out using the USB audio function (via USB cable
connection) or by extracting analog audio output signal (ANO) and
analog audio input signal (ANI) from the ACC 2 connector,
followed by connecting to the audio input/output connector of the
PC sound card. The configuration of components other than that
for voice communication are the same as the basic configuration.
15 NETWORK/KNS OPERATION
15-2
154


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kenwood TS-890S at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kenwood TS-890S in the language / languages: English as an attachment in your email.

The manual is 21,11 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Kenwood TS-890S

Kenwood TS-890S User Manual - German - 196 pages

Kenwood TS-890S User Manual - Dutch - 196 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info