606693
73
Zoom out
Zoom in
Previous page
1/104
Next page
67
USB
VOX AGC AUTO
USB
AGC AUTO
11 OPERATOR CONVENIENCES
DRU-3 DIGITAL RECORDING SYSTEM
(OPTIONAL)
The DRU-3 DRS unit allows you to record
approximately 15 seconds of audio per channel on up to
4 channels. The audio is input via your transceiver
microphone. Once recorded, the audio can then be
transmitted. It is also possible to make longer
messages by consecutively sending the contents of
message memories. Finally, you can even send this
longer linked message repeatedly by using the Repeat
function accessible via Menu No. 39 (REPEAT).
The DRU-3 is useful in many situations:
DX chasing or contest operation where repeated
calls are necessary for extended periods of time
Checking interference complaints to other equipment
(lets you be in two places at one time)
Checking or adjusting your transmit signal or your
antennas if it’s not convenient to be sitting in front of
your microphone
Helping a friend adjust his antenna or receiver when
he needs repeated test transmissions from you
Once you begin using the unit, you’ll likely discover
other applications.
RECORDING MESSAGES
To record a message, you must select the same mode
for transmit and receive. The selected mode must be
SSB, FM, or AM.
Note:
Pressing the
[ ]
(POWER) switch while recording or playing
back messages may cause previously recorded messages or
recordings in progress to be erased.
Refer to INTERNAL ADJUSTMENTS {page 70} for information
on adjusting the recording level.
1 Switch OFF the VOX function by pressing [VOX].
2 Press [REC] to activate the Record Standby mode.
“AP - -” appears.
Press [CLR] to exit from the Record Standby
mode and to abort recording your message. This
does not erase any previously recorded
messages.
3 Press and hold down [CH 1], or [CH 2], or [CH 3], or
[CH 4] and begin speaking into your microphone.
There are four memories for recording
messages. Press the button that corresponds to
the message memory that you want to use.
4 Release the button pressed in Step 3 when you
have finished recording your message.
•Recording continues until you release the key or
the maximum recording time passes (about
15 seconds) whichever occurs first.
Note:
To erase a message, use the above recording procedure
without speaking into the microphone (or disconnect your
microphone) while recording.
MESSAGE PLAYBACK
This section explains how to play back the contents of a
single message memory. Whether checking or actually
transmitting messages, press [CLR] any time you want
to cancel playback. Also, you cannot change the
transceiver frequency while playing back messages.
Note:
Pressing the
[ ]
(POWER) switch while recording or playing
back messages may cause previously recorded messages or
recordings in progress to be erased.
Checking Messages
Use this procedure to verify the contents of a
message memory.
1 Switch OFF the VOX function by pressing [VOX].
2 Select SSB, FM, or AM mode by pressing
[LSB/USB] or [FM/AM].
The transmit and receive modes must be the
same.
3 Press [CH 1], or [CH 2], or [CH 3], or [CH 4] to
play back the message in the respective memory.
For example, “AP 1 - - - - - -” appears while
Message #1 is playing back.
Transmitting Messages (VOX)
Use this procedure to transmit the contents of a
message memory.
1 Switch ON the VOX function by pressing [VOX].
2 Select SSB, FM, or AM mode by pressing
[LSB/USB] or [FM/AM].
The transmit and receive modes must be the
same.
3 Press [CH 1], or [CH 2], or [CH 3], or [CH 4] to
play back the message in the respective memory.
After the message is transmitted, the
transceiver automatically returns to the
receive mode.
73


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kenwood TS-870S at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kenwood TS-870S in the language / languages: English as an attachment in your email.

The manual is 2,76 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Kenwood TS-870S

Kenwood TS-870S User Manual - Dutch - 102 pages

Kenwood TS-870S User Manual - French - 102 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info