686383
10
Zoom out
Zoom in
Previous page
1/26
Next page
EN
2.1.7 Starting the power source
Start the power source by turning the main switch A2 on the front panel to the I position. The
standby indicator A3 turns on.
NOTE! Always turn the device on and o using the main switch, not via the mains socket.
The cooling fan is started for a moment when the main switch is turned to the ‘I’ position. The
fan turns o after a while and then restarts during welding when the machine has warmed up
suciently. The fan continues running even after up to 10 minutes of welding, depending on
the temperature of the machine.
2.1.8 Power source indicators
The following indicators can be found on the front panel of the power source:
• When the green mains indicator A3 is on, the power source is in standby mode. This
indicator is on when the machine is connected to the mains supply with the main switch
in the ‘I’ position.
• When the yellow overheating indicator A4 is on, the machine has overheated. When the
indicator turns o, the machine can be used again.
• When indicator A4 blinks, the machine has encountered a failure. Attempt to remedy the
problem according to the instructions in Section 4, Troubleshooting. If the failure cannot
be eliminated, turn o the machine, and turn it on again. If the failure persists, write
down any fault code that may be shown on the display and contact authorised Kemppi
service agent.
2.2 CONTROL PANEL
2.2.1 Control panel parts
P2
P6P11 P13P5P3 P4
P9 P10
P8
P7
The control panel is used for controlling and monitoring the operation of the power source
and the wire feeder. The buttons are used for adjusting functions. The displays and indicators
reect the operating modes of the machine.
8
KempArc SYN 300, 400, 500, DT 400 / © Kemppi Oy / 1117
10


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kemppi Kemparc SYN 500 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kemppi Kemparc SYN 500 in the language / languages: English as an attachment in your email.

The manual is 1,17 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info