686383
9
Zoom out
Zoom in
Previous page
1/26
Next page
EN
Connecting welding and earthing cables
The power source has two welding cable and control cable connectors. With them, the
welding robot's welding torch and, if necessary, a manual welding torch for tack welding can
be connected to the power source.
Connect the welding and earthing cables as follows.
1. Connect the power source to the electric network according to the instructions above.
2. Connect the earthing cable to the earthing connector A6.
3. Connect the welding cable to the welding current connector A5.
NOTE! Do not overload the welding cables, as an overload may cause voltage loss and
overheating.
You can conect the control cables of manual welding wire feeders or the control cable of a
remote controller to the control cable connectors.
Before starting the welding, connect the earth clamp directly to the work piece in such a way
as to maximise the contact surface of the clamp. The point of connection must be unpainted
and free of corrosion.
2.1.6 Installing the eld bus card
1. Remove the cover of the control unit on top of the power source by unscrewing the
cover screws.
2. Put the eld bus card on top of the interface card and attach with two M3 nuts (see
image).
3. Put the control unit cover back in place.
4. Connect the welding robot's eld bus cable to the control unit connector.
M3 nuts
Field bus card
Interface card
NOTE! Separate the eld bus cable for the welding robot from the mains cables, as they may
interfere with the control logic operation.
7
KempArc SYN 300, 400, 500, DT 400 / © Kemppi Oy / 1117
9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kemppi Kemparc SYN 500 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kemppi Kemparc SYN 500 in the language / languages: English as an attachment in your email.

The manual is 1,17 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info