631711
17
Zoom out
Zoom in
Previous page
1/36
Next page
17
Installation and connection
Installation of turntable
Version with cable duct below turntable (Fig. E)
Check that the O ring is correctly positioned in the groove of the
cable duct (Fig. A). An incorrectly positioned or missing O ring will
allow water to penetrate.
Feed the ends of the cables with the connectors as far as possible
through the cable duct into the interior of the vehicle.
Do not step on the connectors or kink the cables!
Lift the turntable and place it carefully on the mounting plate in the
direction of travel.
The through holes on the turntable must be perfectly aligned with the
threads on the mounting plate. When lowering, make sure that the
cables are fed through the cable duct and are not crushed.
Apply a little sealing glue to the six threaded holes in the mounting
plate and screw the fastening screws into the thread. Tighten the
screws to a torque of 6 Nm.
To prevent water vapour from inside the vehicle reaching the
turntable through the roof duct, place the three cables in the
sealing gasket supplied and insert them as far as possible into the
roof duct. Make sure that no tensile loads are acting downwards on
the sealing gasket as this can cause it to fall out over time.
Figure: E
17


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kathrein CAP 310 - MobiSet 3 digital at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kathrein CAP 310 - MobiSet 3 digital in the language / languages: English as an attachment in your email.

The manual is 1,96 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Kathrein CAP 310 - MobiSet 3 digital

Kathrein CAP 310 - MobiSet 3 digital Installation Guide - Dutch - 40 pages

Kathrein CAP 310 - MobiSet 3 digital Installation Guide - French - 36 pages

Kathrein CAP 310 - MobiSet 3 digital Installation Guide - Spanish - 36 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info