614555
45
Zoom out
Zoom in
Previous page
1/51
Next page
– 43 –
When the pedal sensor has been replaced, change
the set value of function setting No. 50 according to
the newly connected pedal specications.
0 : KFL
1 : PFL
Pedal sensor with two springs located
at the back part of the pedal type is
PFL, and that with one spring type is
KFL. Set the pedal sensor to PFL when
lifting the presser foot by depressing
the back part of the pedal.
11. Selection of the pedal specications
12. Setting of the auto lifter function
When the auto-lifter device (AK) is attached, this function makes the function of auto-lifter work.
1) Turn ON the power switch with switch 󱀙
held pressed.
2) "FL.on" is displayed on indicator A with a blip to
make the auto lifter function effective.
3) Turn OFF the power switch, and turn ON the
power switch again to return to the normal mode.
4) Repeat the operation 1) to 3), and display is
turned to "FL.of". Then, the function of auto-lifter
does not work.
: Automatic presser lifter is provided. (AK is provided.)
: Automatic presser lifter is not provided.
1. To perform re-turning ON of the power, be sure to perform after the time of one second or
more has passed.
(If ON / OFF operation of the power is performed quickly, setting may be not changed over
well.)
2. Auto-lifter is not actuated unless this function is properly selected.
3. When “Automatic presser lifter is provided.” is selected without installing the auto-lifter
device, starting is momentarily delayed at the start of sewing. In addition, be sure to select
“Automatic presser lifter is not provided.” when the auto-lifter is not installed since the
touch-back switch may not work.
󱀙
Display section A
45


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Juki DDL8700B-7 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Juki DDL8700B-7 in the language / languages: English as an attachment in your email.

The manual is 6,58 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info